Yes, in cold climates, kerosene is mixed at 10-20% with #2 FO to prevent gelling.
Naphtha VM&P Grade, Kerosene and IPA can be used to clean it.
Nothing, no reaction without heating.
No, not quickly. You can separate oil from water by freezing it all.
It is difficult to ignite wood or coal using a lit match. The match would burn down and singe your fingers long before the wood or coal would light. Using kindling of dry wood shaving, or thin twigs and dry grass, or paper (with or without kerosene), will ignite with one match and burn long enough to light a fire of wood or coal.
i know of one use. It's called a sonicator... it help dissolute stuff without heating samples...
Yes you can; According to "FlashOffRoad" "Kerosene is routinely added to home heating oil, in large quantities. The furnace doesn't know, or care. The furnace oil pump does not have the same clearances (they are more crude, greater clearances, lower pressure...) and the kerosene won't hurt them. Most will (and often do) run on straight kerosene--here in NH, if the oil tank is outside, the mix will be either 50/50 or straight kerosene. Kerosene doesn't have the same heat values either, you won't get the same amount of power from a gallon of kerosene as from heating oil, or diesel fuel." See full article for more detail <http://flashoffroad.com/Diesel/DieselFuel/about_diesel_fuel.htm> Personally though, I wouldn't add more than 10 gallons per 275 tank full just to be safe.
No way hosea! Is it possible if you have the right setup. It all depends on what type of furnace you are using Not without causing further problems - in mobile home furnaces especially. Using heating oil in a smaller system can result in clogged nozzles and filters causing the system to malfuntion or even worse OVERHEAT causing fire danger. Also straight kerosene won't gel in colder temperatures like heating oil will
yes heating furnace use coal and wood to heat and work.Because you cannot get such high temperature without that .
what type of "HEATING OIL" #2 #4 #6 (Bunker C )
Yes you need freon if you own a heatpump, with a furnace/oil burner you could do without the freon.
With the information provided, I would say no, not for a novice. But it can be done. A new furnace would be cheaper than my fees to change it...pkazsr Elementshvac: Ask your heating contractor for a Green Ecm motor upgrade. We install quite a few of them. It essentially converts your furnace fan to a DC variable speed furnace. http://elementsheating.com
Every Electrical Furnace run by Electrical Current. Without electricity we can't use any type electric furnace. Sometechnical knowledge must be required for maintenance of electric furnace. Spare parts availability like Heating elements/resistance wire, Thermostat/Temperature controller (maybe Digital or Blind controller, Contactor, Insulators etc.
It depends on the furnace design. Some furnaces (and other heating devices) are designated "zero clearance", meaning they can be built into walls without danger of fire. Others require a certain clearance, as spelled out in the manufacturer's installation instructions. Let the manufacturer's instructions be your guide.
You need a furnace because the heat it generates warms your house. Without it, it would be like camping without a campfire!
Graphite is not usually extracted from rocks. Graphite is manufactured in an electric furnace heating an ordinary source of carbon (e.g. coke, charcoal) under high pressure without any oxygen.
with potatoes....OBVIOUSLY
It means that it does not have an air conditioner or furnace installed. HVAC stands for "heating, ventilating, and cooling". HVAC is an integrated system that is not free standing, like a window air conditioner or heater.