Yes, normally, assuming it's 60 cycle (hertz) AC. In the USA, 110 volts as such is no longer used, it's really 120 plus or minus about 5 volts everywhere.
Yes.
No, the applied 110 volt is too high for a 3 volt appliance. The appliance would burn out right away.
NO
no
No, you cannot simply change the wall plug to make a 110 volt outlet support a 240 volt appliance. The voltage requirements of the appliance and the outlet must match for safe operation. You would need to install a dedicated 240 volt outlet and ensure that the wiring and circuitry can handle the higher voltage. It is recommended to consult a licensed electrician for this type of electrical work.
You plug the appliance into the outlet. Israel uses 220-volt household current. Any 110-volt appliances brought from abroad will need a small transformer, which can be bought in appliance stores.
No, it is not safe to plug a 150V appliance into a 110V outlet. The appliance may not function properly and could potentially be damaged. Additionally, there is a risk of electrical hazards or fire due to the voltage mismatch.
No, a 110-volt appliance cannot work on a 220-volt circuit without a transformer or a voltage converter. Plugging a 110-volt appliance directly into a 220-volt outlet can damage the appliance and pose a safety hazard. It's important to ensure that the voltage matches the appliance's requirements to avoid electrical issues. Always check the appliance specifications before use.
The bulb will be about half as bright.
Nominally 110 to 120 volt power strip is okay to connect to a standard outlet.
No conversion needed. These are nominal voltages which range from 110 to 120 volts. It will operate fine on the outlet.
I have never seen a 100 Volt rated outlet. Usually outlets would be rated for 110 to 120 volts for residential use, or maybe 150 volts. The rating is separate from what voltage the outlet is providing. If your outlet is supplying 100 volts, as measured by an accurate voltmeter, you have some problem in your wiring or a faulty outlet. If there is only 100 volts at the outlet get an electrician to diagnose the problem if you are not completely familiar with home wiring. In general you should never use an outlet that has a voltage or current rating less that the device will consume.