0
That is probably not possible due to vacuum issues. If it has drum brakes just convert it to disc brakes. That will give you plenty of stopping power without the need of P/B. click the link
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
When you put a foot on the brakes there is air what is that from?
from the brake booster
How do you replace power brake booster 95 blazer?
The power brake booster on a 95 Chevy Blazer is replaced by draining and removing the master cylinder, unbolting the booster, and removing it from the vehicle. A new cylinder is then put in its place and bolted on.
How do you change the brake booster on a 1984 Chevy Blazer?
first off the brake booster is the round bell lookin thing on the outside of the firewall engine side first u are gonna take off the master brake cylinder which is the thing with the resovoir for the brake fluid there should be two bolts dont take off the lines just loosen the bolts and pull the brake cylinder off the booster now on the booster itself there are 4 or 6 bolts loosen them and under the steering wheel u will see the rod that goes to the brake booster take out the cotter pin on that rod and the brake booster will come right out once out take off the rod on the back side of the booster screw it in the new booster and put back on do all ur bolts and u are good to go
Where do you put brake fluid in a 02 trailblazer?
Pour it into the brake fluid reservoir. It is in front of the brake booster. If you don't know where that is then take it to a service center before you have major problems.
Why does your brakes work with light pressure and not with hard?
You probably have air in the lines or the brake booster is losing vacuum. Have the brakes bleed and have someone put a vacuum gauge on the booster,
What is cause of hard brake pedal on 1993 toyota'S 4runner?
The cause of hard brake pedal is malfunctioning brake booster. Check the hose from the intake manifold going to the brake booster for cracks or leakage, replace if necessary. Check the one way valve located in the middle of that hose, make sure the valve opens when you put pressure on one port.. If all those mentioned are ok, the booster itself needs to be replaced....
Why is my 1988 Rx7 dying when I brake or put it in neutral?
Could possibly be a leak in your brake booster. This happend on my 96' GMC 4x4. Hit the breaks it would hesitate to the point of killing the engine. ( this is caused because the motor has little to no vaccum with a leak in brake booster) vehicle will also be consuming more fuel.
Where do you put the brake fluid in your car if you have a 1990 Dodge Dynasty?
in the master cylander fluid resevoir,which is located under the hood on the front of the brake booster, generally on the drivers side
Why does the Car stalls out when slowing down or stopping but when it is first started it runs fine until it is put into drive?
check the brake booster vacumme hose,its the hose than runs from the intake to the brake booster. if its leaking air the car stall when you hit the brakes or has no power
How do you put in brake booster for Grand Caravan?
Depending on the exact model, you may have a few things to remove in front of it. When front is clear then remove the brake master cylinder then the booster. A lot of awkward wrench work can be made easier if you have a good socket set with universal joints.
How can you determine if a vacuum type brake booster is operating properly?
With the car moving slowly ( in a safe spot like carpark) put on the brakes and note stopping pressure needed, and distance to stop. -Now get moving to the same speed again and turn off engine, then brake the car. If it's harder to brake, then booster IS working.
Where do i put clucth fluid in the Isuzu Rodeo?
There should be a small resivor by the brake booster on the driver side of engine compartment for clutch fluid.
