0
What else can I help you with?
If you where to put a turbo in a 1992 eagle talon what is the best type to put in?
The 14b turbo the TSI's come with stock.
Where is the place where you put freon in a 94 Geo Prism?
The low side fitting should be on the left side of the firewall
Is it possible to turbo a 92 bravo G6 engine?
You can put a Turbo on your 1992 engine. You will need to purchase a air intake Turbo modification kit.
Can you put a 1991 Dodge spirit turbo engine in a 1992 Dodge colt?
It is not a direct fit.
What causes a 1994 Geo Prism to cut off once you put it in drive?
Several things can cause this from ignition to trans. Take it to a garage and have it checked out.
Why would a Geo Prism that has a new coil put on it suddenly start missing really bad while driving?
Bad plugs or plug wires.
How do you put a front license plate on a 1995 geo prism?
i have a 95 Prizm and i just bolted the plate to the bumper. it does the same the as a bracket. but it cost no money.
How do you change the oil on a 1995 Geo Prism?
The oil on a 1995 Geo Prism is changed by placing a drain pan under the engine, removing the oil filter, unscrewing the drain plug, and allowing all the old oil to run out. A new filter is then installed, the drain plug put in, and the engine refilled with new oil.
What other kind of motor can you fit in a 1996 Geo prizm?
i read in a car magazine that a guy put a twin turbo 3.8 liter v6 in one
What engine is in the 1992 Geo Prizm?
well i have a geo metro and i have a 3 cil in mine but they put a 4 cil in the 90s The Geo Metro is made by Suzuki. The Geo Prizm is made by Toyota and is built in California on the Corolla chassis. The 1992 Geo Prizm has a Toyota 1.6 Liter 4 cylinder. Base engine is 102 H.P. GSi engine is the same 1.6 but with 130 H.P.
Can you put a 1994 geo metro engine in a 1992 geo metro?
Yes you can. All Geo Metro engines are compatible from 1989 - 1997. Just make sure that they both have the same transmission or you'll have to do a lengthy and expensive conversion.
How do you install the AC belt on a 1992 Geo Prism?
You haav to loosen the idler pulley lock nut and turn the adjusting bolt to let the tension off the old one. Put the new one on and tighten the adjusting bolt until the belt is tight and then tighten the idler pulley lock nut.
