If it will bolt up to the mounting holes and the pulley is the same diameter and type, yes it will work. Of course the pulleys must line up. But why would you want to go to all the trouble of changing a water pump and installing a used one? Unless it is NOS.
There are different ways. One is that the 351w fuel pump bolts to the timing cover,the 351c bolts to the engine block. Water flows through the 351w intake manifold and does not on the 351c. The 351w has inline valves and the 351c has canted valves. The 351w has squared intake ports and the 351c has huge round ports. Hope this helps some.
The simple difference between the 302 and 351w is simply deck height. The 351w is taller. They share a majority of interchanging components. Both the 302 and the 351w have a water cooled intake meaning a water bypass hose between the water pump and intake. The 351m would have an aircooled intake meaning no bypass hose. Also the head design of a 351m would make the engine look a lot larger (wider) than the 302/351w
Where is the Water Pump located and how do you replace it on a 1990 Chevy Corsica?
how do I remove a water pump on a 1990 4.5 liter cadillac engine
The water pump is in behind your timing cover.
On a 1990 Plymouth Voyager 3.0, the water pump is located behind the timing cover. The timing belt is what drives the water pump.
You can begin by setting the new water pump onto the 1990 Jaguar water pump platform. Tighten the water pump retaining bolts. Attached the water return hose. Put the water pump belt on. Fill the cooling system with coolant.
how do I remove the water pump from my 1990 Isuzu truck?
First thing is count the valve cover bolts. If it has 6 then it is a 302 or 351.The 351W has a taller deck height than the 302. (a 302 will have the intake almost flush with the base of the distributor... where it goes into the block..... a 351w will have about 1/2 inch lip there where the intake meets the block.) The lower thermostat housing bolt on the 302 will be below the top of the water pump and you won't be able to put a socket on it. On the 351W you can remove the bolt with a socket. 351C manifolds are dry, no water passages or thermostat housing....thermostat housing goes into the front of the block. 351w uses 18mm spark plugs and the 351c uses 14mm spark plugs. 351w fuel pump bolts are on left & right sides. 351c fuel pump bolts are on the top & bottom.
water pump is on front of motor , the fan is bolted to the water pump There wasn't a Concord until 1993
you have to remove the belts and water pump pulley the water pump is located behind the timing cover.
Water pump is located below alternator on passengers side