Yes you can but you will need to modify the bolt holes in the intake manifold.
The TBI intake 4 center bolts, 2 on each side will not line up with the heads. Must drill them out just a little.
nothing. but the intake will be diff.
On drivers side screwed into the back of block behind intake with 1wire plugged on to it.
That's what the gas pedal does.
1983-1987 454 out of a light duty truck
No, it is mounted on the engine block.
Yes, they will bolt on, but no, they will not work. They are intended for a reverse flow cooling system, and also the intake bolt pattern is different from the pre-86 small blocks.
There is 8 on that engine. There's 2 in the back of the block, 2 on each side of the block and 2 in the front of the block.
The fuel pump relay of a 1983 Chevy Camaro can be found inside the relay fuse block. It provides power to the fuel pump.
Where the upper radiator hose connects to the engine the thermostat is located under the neck protruding from the block.
The Chevy Luv
Heads or Tales was created in 1983-09.
It should be bolted to the block on the passenger side, front, down low near the motor mount.