The surgeon will try to identify and preserve your parathyroid glands if possible. Unfortunately this difficult and sometimes impossible as these glands are very tiny and literally embedded in the thyroid. If the parathyroids are inadvertently removed it results in a condition called "hypoparathyroidism," which is common and treatable.
Surgery is the only way to remove the tumor
The car has only one transaxle, AKA transmission, then no, you cannot remove the tranny without removing the tranny. If you mean without removing CV Axle or drive axle or Axle shaft or CV shaft (same thing) then the answer is still no. You cannot remove the transaxle without removing the drive axle/CV shaft.
yes you can remove the fan clutch without removing the rad. it is tight but it can be done. it is easier with the Rad removed
by removing it with cutting plyer without bending them or twisting them with a hammer
You must remove the wheel/tire in order to remove the front strut.
It is not possible to remove the power steering pulley on a 1997 Buick Le Sabre without removing the power steering pump.
There is no need to remove the timing belt to change the thermostat.
Answering "Can you remove one carburetor from a 1983 gl11oo goldwing without removing all four?"no screws hold carb to airbox access from inside air box
The parathyroid gland secretes the hormone parathormoneor parathyroid hormone (PTH).The function of PTH is to increase the concentration of calcium in the blood. It does this in three ways:increasing the release of calcium from the bonesincreasing the reabsorption of calcium from the kidney tubulesincreasing the absorption of calcium from the intestinePTH is a polypeptide hormone, made up of 84 amino acids.See the related link for more information.It is called PTH, or parathyroid hormone. It is part of the endocrine glands and to look this up i'd suggest a physiology book
remove tire. remove bottom mount. pullout through bottom.
You can remove the oil pan from your 2002 Chevy Cavalier, without removing the motor. The oil pan is held in place with retaining bolts.
no it is not possible