answersLogoWhite

0

There should not be any problem as long as the single cylinder engine has the same horsepower for handling the load, and the mounting bolt holes match up.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How can you get the lawn mower engine unfroze?

Try kerocene in the cylinder head ..


Can you replace your 12.5 Briggs and stratton tractor engine with a 16hp Briggs and stratton?

Yes, most all of the Briggs single cylinder engines are exchangable. You just need to be concerned to make sure that you don't under power your mower. In your case that is not a problem.


What is the difference between a single-acting and an opposed piston engine is?

Single-acting? You mean like a single cylinder engine, like in my lawn mower? The biggest difference (besides the obvious "an opposed engine has more cylinders" is that an opposed engine has more torque. On a single-cylinder four-stroke, you've got the cylinder moving under input energy--the burning gasoline--for one stroke, and under stored energy from the flywheel for three strokes. If you have a two-cylinder engine, you have two strokes where the engine is moving under input energy--each cylinder has one--and two strokes using stored energy. If you have a four-cylinder engine, each stroke is moving under input energy.


How many valves does a 2 cylinder brigs startin lawn mower engine have?

Four


Where is the spark plug on a craftsman riding lawnmower?

The answer will depend on what engine is in the mower. If it is a single cylinder more than likely it will be in the front of the engine. If it is a twin cylinder the plugs wille on the sides of the engine. Either way look for a thick black wire going to it about the thickness of a pencil. It will be what that wire goes to on the lower end of the wire.


Who Built a one - cylinder gasoline engine?

Any maker that produces lawn mower engines.


How does the oil get to the motor in a mower?

The Smart Aleck answer is, "You put it there." When you pour oil in via the fill hole, you're pouring it directly into the crankcase of the engine. I believe most simple, single cylinder, 4-cycle lawn mower engines are "splash systems". In which case, it's up to mechanical agitation to splash the oil around while the engine is running, ensuring that the valve components and cylinder walls are lubricated.


Your sears 18 hp lawn tractor suddenly stopped with a bang?

blew engine cause of low oil.... junk the mower engine & replace or pitch the whole mower... your choice


How do you fix a lawn mower that has been run without oil?

Replace the engine...End of story.


How much gears does a one cylinder car have?

Because the number of gears in the transmission has NOTHING to do with the number of cylinders in the engine, there is no way to answer this completely. However, since a one cylinder motor is only possible with a 2 stroke and a HUGE centrifuge, there would be no way to have multiple gears in a one cylinder engine. It would have to be a generator of some sort with a single ratio clutch system, like one could find in a lawn mower type engine.


How can you replace muffler on 4.5 hp Briggs straton push mower engine?

It just unscrews from the motor


What do you do about a flooded riding lawn mower engine?

Turn off fuel, remove spark plug/s crank motor a few times, clean plug/s and replace. That should clean out the cylinder/s. Should start.