It would be unusual to have the same brake pads front and back. That is not to say it does not happen but normally the brake pads on the driven wheels are bigger than the passive wheels.
you have to push the brake cylinder back into the caliper using a "C" clamp
Length of back brake line to replace. hole in it between front and back door
Replacing brake pads is a task required for every vehicle. To do this, lift the Vespa, remove the wheel, remove the hub, remove the caliper, remove and replace the brake pads, put the caliper back on, replace the hub, put the wheel back on and lower the Vespa.
To replace the brakes, lift the car on a jack, remove the tire, brake shoe and old brake pad. Next put in the new brake pads, put the brake shoe and tire back on the car, and lower the car.
If you are talking about the steel brake lines, most likely the rear lines, then replace both from front to back.
No. You will only need to replace the brake shoes if they are worn down. Generally the front brakes do 70% of braking leaving the rear with 30%, which will cause the front pads to wear first. What is important however is that you replace either front brakes or rear brakes as a set. i.e. if you're replacing the front brakes do the right and left side.
Over 20 mph, front brake then add back brake. Under 20mph a little front but mostly back brake. Under 5 mph back brake only. In an emergency front brake hard and add back brake hard. Change down after braking, even if you brake to a standstill.
Changing brake rotors is pretty easy. One lifts the car, removes the tired, brake shoe and then the brake rotor. Next replace the brake rotor, put the brake shoe and tire back on the car and lower it back to the ground.
Lift the car on a jack, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Put the new brake pad in, replace the brake shoe/caliper, put the tire back on and lower the car.
The front have pads, and the back have drums. If you are needing to replace them, they cost around 60. What is it you needed to know?
One lifts the car on a car jack, removes the tires, remove the brake shoe, remove and replace the brake pad. Then one has to replace the brake shoe in the correct position, then put the tired back on the car.
How to replace a brake light on a nissan Tiida hatch back.