You should replace all. That being said if it was my car it would get 1 rod.........
Another OpinionIn general, if a connecting rod needs to be replaced, it's because the bearing has worn out and the rod was damaged.A good machine shop can recondition the remaining rods and bring them back to original condition, then you only need to replace the one rod.
The key, however, is to have all rods reconditioned, even the new one should go through the procedure since they are sometimes not perfectly straight.
You'll no doubt need to recondition or replace the crankshaft if a rod has failed; when that happens the crankshaft often goes through some difficulty. If it were mine, I'd have the block "align bored" just to make certain that nothing terrible has happened.
Beyond that, the cylinders and head needs to be serviced just as any other engine while you have everything apart.
Normal mechanics tools and a good torque wrench.
SATURN IS 10000000000000000000000C HOT
It is normal to replace them.It is normal to replace them.
it is kind of normal
23 pairs
The space between each port is adequate for connecting 10 normal sized USB devices simultaneously.
Yes, Saturn has a lot of rings. The rings are made up of thousands of small bits of ice or rock. They are so close to Saturn that a normal moon would be broken up there by Saturn's gravity.
Saturn , Jupiter , Uranus and Neptune, all of the rings can be seen with a normal telescope, but not , Neptune you have to block out planet to see them.
The stock tires are usually 35 psi
Nope........... You can bypass it if its leaking and run the vehicle as normal..........
Osteoporosis ... bone density may decrease, but may not yet have dropped below her age-matched normal range.
False