Can you replace the outer boot for an '89 probe with out special tools?

No offense but if you don't know how to do it don't" You will need special tools and special equipment to be able to do it.

no special tools are needed

Basic hand tools should be enough.

Common hand tools, sockets and wrenches. Nothing special.

Do you need any special tools.

Normal mechanics tools and a good torque wrench.

The oil pan must be removed. No special tools required, just normal mechanics tools.

The ball joints are bolt on parts that don't require any special tools to replace.

there should be 4 small holes in the front there are special tools in the shape of a U and you need two put the prongs of the tools in the holes and push this should loosen the radio so you can pull it out

Take it to a garage as you need special tools and the alignment has to be set when you replace them.

You can use a very small screwdriver to remove the stereo and replace it with the new one, or you can purchase special removal tools.

You have to remove the steering wheel, and it requires special tools.

Remove old one and replace. Several specialty tools are required. The last step is a front end allignment.

Do I need any special tools to replace front wheel bearings on a Saturn 2002 L200?Also what is the procedure for doing so?

No special tools are needed and once you get the dust cover off the drum you will see just how easy it really is. Make sure you pack the new bearings well If you are doing this to replace the brakes it should have over 150000 miles on it. I have never seen them wear out before that. Ray Thanks Ray. My vehicle has 176,000 miles on it, runs like a top, but has a…

It is pretty technical and special tools are needed. Take it to a garage.

if you are not mechanical, replacing a fuel injector is a specialist job requiring special tools

This is fixed with adhesive and requires special tools to do properly.

The brakes on the Villager are as straight forward as the brakes on a 1965 Mercury. Only normal brake tools are required.

Not an easy job requiring special pullers and tools. I suggest taking it to a garage.

dont try you need a lot of special tools and remove timing belt

There are two. They are accessible from under the rear seat cushion with special tools.

haha you dont know and no you dont mate

the only special tool u may need is a fluel quick connect tool

It is on the left side of the block, only tools required are 13 and 15 mm sockets and wrenches.

No you dont need any special tools to change the water pump you just need to create space around the area because its in a closed in spot and it is alot of screws to take off ..

Find it in the fuel line. I don't think it requires any special tools.

special tools are required to do this job.slide hammers impact tools.yhis is not a job for diy!!

you either but the special tools for the timing belt or take to a reliable shop that is familiar with Volkswagen engines.

Telescopes, spectroscopy, and a "Voyager" space probe.

I Have no Idea lol i dont believe you need any special tools and it sits in front of the crossmember and bolts to that, and tie rods, and hoses hooked to it

There are many bushings in most vehicles. Some can be replaced easily and some require special tools and equipment. It all depends on what year, make, model and bushing you want to replace.

The steering wheel must be removed and yes it requires special tools. This car has a drivers airbag and I would recommend you take this to a professional for that reason. Serious injury can occur if you make a mistake.

Trace the fuel lind from the tank to the engine and the filter can be changed with special tools from the parts store.

several special tools are REQUIRED to perform this task, which involves removing the steering wheel.

Take it to a pro a lot of special tools and know how req. A lot of shops won't do this job.

you have to remove the steering wheel and the turn signal. this requires special tools that can be purchased or rented cheaply.

Do we need special tools to install the timing chains on 2003 ford f150 4.6 engine

Not a DIY job. Specialized tools are required.

The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.

They are pressed in and out with a set of special tools.

id bet the drive shaft,maybe both of them are bad,as the outer cv joints do go bad.around 100 bucks for both if you do it yourself....,and a few special tools....

Find it under the car in the fuel line and it takes special tools available at the parts store.

They are replaced as a complete unit, there are special tools(a large thin wrench) that you can borrow from an auto parts store.

No, no special tools needed, just common hand tools.

Police officers have special tools because when tere is someone breaking the law they will need special tools to stop them from doing any harm. Police officers keep their tools in a belt they wer around their waist.

Locate screws, removing panels if necessary. Disconnect wiring, remove item. Replace. Reconect, relocate and recover. That gos for house, car or boat. Ufo's might require special tools or skill! Bear in mind, use the best quality correct fitting tools as you go

It requires some expensive special tools and specialized knowlage to repair a rack and pinion steering gear, it is easier and less costly to replace the rack and pinion with a remanufactured unit than to purchase the special tools to repair a rack and pinion steering gear

Under the car about midway to the engine in the frame rail> It takes special tools available cheap at the parts store.

Find it by tracibng the fuel line from the engine to the tank. It requires special tools available at the parts store.