0
truth is you can, but i don't know if it'd mess up your combo because of the wattage that you're running through it.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Can you use a combo amp and hook it up with a cabinet speaker?
You are not guarenteed to get a great sound, but typically it is possible. A combo amp is just a cabinet and pre-amp/power-amp(head) in one box. If your combo has a line out that you can use to run speaker wire to the back of your speaker cabinet, then most likely it will work. The issue is, will your amp have enough juice to run the speaker cabinets with enough volume? For instance, my head is running 750w into a 4x12 at 4ohms. If were to run a 100w combo power-amp into the signal then I would likely have break up of signal and loss of sound clarity trying to get enough volume to be effective. If your combo has tons of extra juce, however, go for it!
How do you run an amp?
well, you set up your power, remote, and ground wire. Then you need to run your RCA cables to the back of your head unit. After that, you just connect your speakers to the amp and your done.-Shocker
Can a guitar amp head be used through a bass amp cab?
Yes. I've seen this done several times successfully, although the sound quality just isn't the same. Make sure the cab can handle the amount of watts you are using. NEVER run a bass guitar through a guitar amp head or speakers.
How do you hook a marshall amp into a pa?
You can either run a patch cord from the "line out" jack on back of your amp to the board (or head of the snake, if your band has a snake for the PA). If your amp doesn't have a line out jack, you can place a mic in front of your amp, and plug it in to your board.
How do you connect a car stereo to an '88 Mercury Grand Marquis?
on mine i had a premium sound system package stock. i had to bypass the stock amp to run the head unit even though i am running it on the pre amp from the head unit. the speaker will notwork unless you bypass the the stock amp.
Can you run a guitar amp through a bass cabinet?
Yes, just don't cross the wires.
What is a bass head?
A bass head is the end of the bass guitars fretboard (where the tuner knobs are). If you are referring to the bass guitar itself, the above answer is correct. It's the top end of the bass guitar, where the machines, or tuning keys are located. If you're speaking in terms of a bass amp, it's the type of amp that does not have the speakers built into the same cabinet that contains the amp. instead, you run a patch cord from the amp, or "head" to a separate cabinet.
How do you hook up two car stereo amplifiers one to each sub in there own box can you run a power wire out of one amp over to the other amp?
Do you mean the main power from the battery or the remote turn on? If you mean the battery power, usually amp add on kits come with distributor blocks. You make one run of power wire from the battery to somewhere close to your amps. Then, hook that wire to the block, and run a new piece of wire from the block to each amp. If you mean the turn on lead, just make one run from the head unit to the first amp, and then run another piece from the first amp to the second.
How do you fit an amp in a Peugeot 106?
depends on power needed. if it's small, you can take power from the ciggy lighter - about 10 / 25 amp, run that under carpet to boot, of more is needed you'll need to run a cable from the battery. then the audio leads from head unit through dash down, and again under carpet.... run but you'll likelly need to remove at least one of the front seats and deff the rears
Do you have to bypass a factory amp in a 2002 Chevy sub?
U run you own set of speaker wire from head unit to each speaker
Can you run all your speakers 4 speakers 60w 2 tweeters 100w and 2 subs 400w all in RMS through one amp 1200w?
You should be able to run every thing if it's a multiple channel amp, but with out kno wing how many channels your amp has it makesdiagnoses harder.(Mono amps will not be able to run that many speakers)
Where is a hole in the firewall to run a wire for an amplifier in a Mitsubishi mirage?
There is none. Use your head, think outside the box. There are otherways to run your 12v+ from the battery to where ever you might be installing your amp. (hint: Along driver side fender, through electrical wiring rubberized boot down by the door.)
