0
What else can I help you with?
What is wrong when I try to start my 1994 aerostar van and it just clicks?
Dead battery? try jumping it off. bad starter solenoid? bad starter?
No power to the starter after trying to jump start another vehicle all fuses are good can start the car by jumping the starter where do you start looking now?
check the alternator
Jeep Cherokee will not start without a scew driver jumping the ground wire to the starter?
Sounds like starter solenoid needs to be replaced
1988 blazer wont turn over have great battery replaced starter can start jumping starter post to post wkey on any sugestions?
check solenoid
How does tapping a starter in a 1994 dodge caravan help it start?
The starter has failed and needs replaced. Somthing inside the starter makes connection when you tap it.
2000 ford focus wont start tryed jumping didnt start makes clicking sound?
The starter is bad and the brushes need changed you can change them your self for dirt cheap or replace the whole starter for more money.
Why would 98 Cherokee not start turn key everything comes on no crank can jump starter terminals and wil start cleaned neutral safety switch already?
your ignition switch or the starter solenoid is bad try jumping the solenoid instead of the starter, if this does not work, then change solenoid
My 1994 Nissan Quest won't start?
If your 1994 Nissan Quest won't start, you might have a dead battery or a bad starter. You could also have a tank that is empty of fuel.
Where is the starter relay on a 1994 Corsica?
Where is the starter relay switch on a 94 Corsica V6 yam
Why is the only way to start 1994 escort engine will not turn over is to push start what is wrong?
Sounds like you need a new starter!
Starter location on 1994 Altima's Engine?
Where is the starter located on a 1994 altima engine
1989 jimmy starter making vacuum sound. When we jump the solenoid the starter makes only a whirling noise much like a vacuum cleaner. Any ideas on what is causing this?
IF you are jumping the right set of terminals, then: The solenoid is failing to 'push' the starter (pinion) into place and engaging the flywheel. The solenoid needs to be replaced, although the pinion and plunger is most likely worn: and replacing the whole starter assembly is normally not that much more expensive. Please note however that you could be jumping the power to the starter only thereby bypassing the solenoid. Solenoid: ---- P ------ R -------- S ----- X ----- P = Power or Battery cable X = Starter motor R = Run position (Starter bypass coil power) S = (Purple wire) Start from Key Be sure you are jumping power to the START wire, not the X starter terminal.
