0
Can you swap the tran and transfer case in a 1986 suburban 2500 4X4 into a 1993 2500 Chevy pickup 4X4?
Wiki User
∙ 15y ago
quick answer...no in the 86 the transfer case driveshaft output was on the passenger side in 93 the were drivers side so unless u plan on swapping axles too then no if u switch axles then yes but that may affect steering suspension ride height clearance problems...
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
1986 Chevy K10 Pickup Fuse Box diagram?
need picture of fuseblock for 1986 chevy k10 pickup
What is the horsepower of a 1986 Chevy pickup with a 305 motor?
the 1986 Chevy truck 305 HO produced 180 hp
Where is the ignition coil on a 1986 Chevy silverado pickup truck?
no
Can you swap the rear end from a 1977 threequarter ton two wheel drive pickup Chevy to a 1986 half ton two wheel drive suburban?
If you have the "know how" you can.........to answer your question, yes, it can be done
What is the horsepower of a 1986 Chevy Suburban with a 350 motor?
The horsepower rating on a 1986 Chevy Suburban with a 350 motor is between 180 and 200. This allowed these sport utility vehicles to perform well when weighing in excess of 5,000 pounds.
Will 1986 Chevy pickup frontend fit on a 1976 Chevy pickup?
It should, may have to swap the whole front clip. Resulting in changeing out the core support..
Where is the gas float located on 1986 Chevy pickup?
It is inside the gas tank.
Will the wheels from a Chevy S10 pickup fit a 1986 gmc vandura van?
No.
What is the horsepower of a 1986 Chevy suburban 4 wheel drive 350 engine?
It has 210 H.P.
What is the curb weight of 1986 Chevy short box pickup?
i think my 86 was about 1700kgs wet
What is the spark rotation sequence on 1986 July 1986 Chevy S-10 pickup 4-cylinder AT?
1-3-4-2
How do you change a washer pump on a 1986 Chevy Pickup?
If it is on the bottom of the wiper motor-just unclip and it twists out
