Yes
try adding cyanuric acid (stabiliser) it will stop the the chlorine fromdissipating so quickly as a result of sunlight.
depending on the volume of chlorine you put in your pool. Chlorination or simply the adding of chlorine to water is extensively used in many water treatment facilities primarily to disinfect or kill harmful microorganisms, such as bacteria.
Do you mean that adding a little chlorine made the reading go from 0 to a higher level? You should shock your pool once a week with 1L of liquid chlorine per 10000L of water in your pool. You need to add enough chlorine to break apart the combine chlorine (the combination of chlorine and dirt which doesn't sanitize.) If you don't add enough at once, it will be used up and the chlorine reading will remain low.
The following method will give 0.5% Chlorine solution Materials required: 1 litre water and 3 tsp bleaching powder.(see that it is 33.3% Chlorine) Add three teaspoon bleaching powder, make a paste with hand, after adding a small quantity of water.(there shall be no solids felt) Add remaining water. The resultant liquid will appear something like toddy. Now you have 0.5% Chlorine solution
You'd still have poisonous chlorine gas, and it would be as toxic as it was before you added the neutron. But there is more news, and it's bad. By adding a neutron to each of the atoms, you'd end up with unstable isotopes of chlorine, which means that all your chlorine gas is now radioactive and presents a radiation hazard as well as being as poisonous as it was originally.
Yes you still need a pump and filter. The saltwater system generates chlorine and eliminates the need for chlorine tabs. You will still need to keep the water balanced and continue normal pool maintenance.
Stop adding salt to the pool and use tablets and shock when needed.
Turn of the salt water chlorination and start adding chlorine the same as you would in an ordinary pool. The salt water in the pool will become less salty over time so you don't have to worry about changing the water. You could tidy it up a little by removing the saltwater chlorinator element or you could just leave it.
By adding salt on it
The chlorine is reacting to minerals in the water.
No you will not have a salt water pool. yes you will have salt water but the actual electronic plates found in a genrator converts the salt in the water to chlorine to sanitize the pool water. A: You have to have the mechanical device to produce the chlorine in a salt pool. THE SALT A MEANS TO PRODUCE CHLORINE FOR YOUR POOL!
Yes you can. It is recommended, mostly, to keep your salinity between 3000 - 4000ppm. This way the generator can do it job or producing enough chlorine to keep your pool sanitized. Adding too much salt can damage your cell and possibly deck and equipment. Good luck Robert
Adding salt to water is not a chemical reaction, nor is it a chemical change. When salt dissolves in water, this is an example of a physical change. Although the sodium and chlorine ions separate in the water, no chemical reaction takes place.
its the cleaning
Yes, this is the simplest method.
Chlorine will dissipate after a couple of days of its own accord the only way to keep chlorine in is to keep adding it.
. All water is chlorinated by adding chlorine gas to it or by adding calcium hypochlorite or sodium hypochlorite. The term "chlorinated water" is misleading, as the final product is not chlorine, but a dilute solution of hypochlorous acid.