Yes you can. You can change from a .50 to a .44 by just changing the barrel. The bolt stays the same. You can also change to a .357 but that requires a different bolt as well. The magnum research company sells all these conversion kits on their website.
yes
The oil pressure sensor on a Dodge Caliber is under the intake manifold on the front of the engine.
Dodge does not use inertia/reset switches.
Begin by removing the retaining ring at the top of your 1993 Nissan Quest ignition switch. Slide the ignition barrel out. Remove the wiring harness from the end of the ignition barrel. Reverse the process to install your new ignition switch.
The barrel is not timed properly to the switch.
Turn off the sparking switch by pressing it. Then push a barrel over to the rock and turn the switch back on. This will set off the explosive and clear the rock. Then turn off the switch again and push another barrel over so you can blast the rock wall.
Ur life suck that why
Leave it alone. Don't think about it.
Inhibitor switch reduces engine power to avoid shock while automatic transmission changing gears
In the Diamond Mine, blast the wall (and the rock that is in your way) using the explosives stored behind the elevator. Turn off the sparking elevator switch, and slide the barrel to the right. Turn the switch back on to set it off. Use one barrel for the rock and one for the wall. You get as many as you need.
How do i find the instructions for changing out the fan switch assembly in a 2001 Mercury Cougar?
changing the wires to the on-off switch.