yes you can take them right after you promote
Jim Swigert was the command module and he was in the command module, but both Jim Lovell and Fred Haise had gone to the lunar module, just before separating.
A camera mounted on the side of the lunar module was deployed by Armstrong before he made his exit from the module.
On the third day of Apollo13 mission, just as the astronauts were getting ready to separate from the command module, Lovell had gone to do the final check up before they went in the lunar module, the command module exploded.
The Service Module, jettisoned after returning to earth, but before the Command Module began reentry.
Driver's airbag module - on steering wheel. Passenger airbag module - dashboard, right side. Airbag control module - under center console in front of the gear shifter. Please remove the battery connections and wait AT LEAST 30 minutes before touching anything.
Registers
The command module was covered by a white escape system before take-off; that was jettisoned shortly after launch to reveal the silver module.
You need to disconnect it from the circuit before you test it for resistance.
take it to a garage take it to a garage more than likely its your ABS module. def. find someone to run a diagnostic on it first before you get a new module. Dont buy a new or reused module either. take you old module out and have it rebuilt. you can get the module rebuilt for 100-200 dollars. a used module will go out on you very soon and a new module will cost at least 1000 bucks. if its not the module, check your abs sensor and your brake sensors from your brake pads. i had the same problem and my abs module was dead and i also had a short in my wear sensor for my brakes.
The Distributer module on "92" S-10 Vin code "W" or "Z" is located on the distributer,you must remove the distributer cap to gain access to the ignition module. Once you have gained access to the ignition rotor it is always necessary to always test the module before replacing it.
The module is in the distributor. You have to dismantle the dissy to replace. The module is conected to a small coil by push in clips. The coil sits around the center spindle and the module is held by 2 screws. White heat sink grease is supplied with the new mod. and is applied to the back before screwing down. The wires then clip on to the module. Usually when gone, the car stops and can be re-started after a while..this goes on......
Neal Armstrong, Edwin Aldrin, and Michael Collins traveled to the moon and entered lunar orbit. Armstrong and Aldrin descended from orbit in the Lunar Excursion Module, walked on the surface briefly and collected samples, before returning to the orbiting Command Module. Collins stayed in the Command Module while Armstrong and Aldrin were away on the surface, before they beamed back aboard.