The module is in the distributor. You have to dismantle the dissy to replace. The module is conected to a small coil by push in clips. The coil sits around the center spindle and the module is held by 2 screws. White heat sink grease is supplied with the new mod. and is applied to the back before screwing down. The wires then clip on to the module. Usually when gone, the car stops and can be re-started after a while..this goes on......
The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
were is ignition drive module located in the engine
The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
There is no ignition module in a '84 laser. They have a coil and distributor unless it has been modified. If you don't get a spark across the points in the distributor when you try to start the engine you probably need a new coil.
under the dist. cap
Where is the key in the ignition warning chime module located on a 1990 Ford ThunderbirdRead more: Where_is_the_headlight_warning_chime_module_located_on_a_1990_Ford_Ranger_2.9
1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.
The most common fault is the ignition module in the dissy which breaks down when warm.
A 66 Mustang regardless of engine doesn't have an ignition module from the factory. It uses breaker points inside of the distributor housing to directly control the ignition coil.
You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.
On the distributor
The van should have electronic ignition, resistors are built into the ignition module and cannot be serviced. The module is located on the left inner fender below the master cylinder.