The most common fault is the ignition module in the dissy which breaks down when warm.
you need to replace the cam shaft positioning sensor
Laser
If you able to restart after a few minutes, then your CMP is defective.
Laser consumables refer to the parts that can be replaced in a laser cutting machines, such as filters, nozzles and optics. A laser cutter is a machine that cuts materials very accurately using a laser.
it cuts out precise shapes on plastics such as acrylic
The radio could have a short in a wire that is being bounced and causing it to turn off. It also could be the radio is going out and should be replaced.
Smash Cuts - 2009 Crash Course in Driving 1-4 was released on: USA: 11 September 2010
The maximum size that a Ponoko laser can cut is 790mm x 384mm (31.1 inches by 15.1 inches). The reason for this is because their laser cutter is a machine, and does not allow for bigger cuts than this.
Fuel??
98 Oldsmobile 3.8 cuts off will driving wait a few min's an it cranks back up
Ignition switch
main relay