0
What else can I help you with?
How do you install a PCV valve on a 1990 Corsica?
you have to take the plenum off first
How do you install power valve blowout protection on holly 600?
To install power valve blowout protection on a Holley 600 carburetor, first, remove the carburetor from the engine and take off the fuel bowl to access the power valve. Then, replace the existing power valve with a blowout protection valve, ensuring it fits snugly in place. Reassemble the fuel bowl and carburetor, ensuring all gaskets are properly seated to prevent leaks. Finally, reinstall the carburetor on the engine and check for proper operation.
How and where would you install a shut-off valve on a wall-mount faucet?
I take it that you are mounting it out side, put the shut off valve in side, with a drain on it,
How do you install the valve cover gasket on a 1988 Cadillac DeVille?
take off valve cover throw away old gasket replace old gasket with new put valve cover back on pwn
Can you take stool softener?
Yes, You Do Take Stool Softener By The Mouth It Usually Come As A Capsule, Tablet, Liquid And Syrup Which You Take By Mouth But When Using Stool Softener Always Read The Instructions On The Back Of The Package. Hope This Helps! :)
92 Mercury Topaz smoking a lot behind valve cover why could this be?
Most Likely A Leak, Caused By The Gasket Needing Replaced On Valve Cover. When You Install Gaskets Put In A New PCV Valve This Should Take Care Of It.
How can I perform an at-home cat stool test to check for any potential health issues in my feline companion?
To perform an at-home cat stool test, you can collect a fresh stool sample from your cat and take it to your veterinarian for analysis. This can help detect any potential health issues such as parasites or infections in your feline companion.
How do you replace the expansion valve on a 2002 Buick rendezvous?
To replace the expansion valve on a 2002 Buick Rendezvous, first, ensure the AC system is fully discharged to prevent refrigerant exposure. Locate the expansion valve, typically found near the evaporator, and disconnect the refrigerant lines and electrical connectors. Remove the mounting screws to take out the old valve, then install the new valve, reattach the lines, and recharge the AC system with refrigerant. Make sure to check for leaks after the installation.
Where is the heater control valve on your 1988 Cadillac fleetwood d'elegance and how do replace it?
The heater control valve on a 1988 Cadillac Fleetwood d'Elegance is typically located near the firewall on the passenger side, connected to the heater core hoses. To replace it, first, drain the coolant from the radiator, then disconnect the hoses attached to the valve. Remove the mounting screws to take out the old valve, install the new valve in the same position, and reconnect the hoses. Finally, refill the coolant and check for leaks.
How do you change the egr valve on a 2001 Pontiac aztek?
To change the EGR valve on a 2001 Pontiac Aztek, first, disconnect the negative battery cable and locate the EGR valve, which is typically on the engine near the intake manifold. Remove the electrical connector and the mounting bolts securing the valve, then take out the old valve. Clean the mounting surface to ensure a good seal, install the new EGR valve, and reattach the bolts and connector. Finally, reconnect the battery and start the engine to check for proper operation.
How do you replace the egr valve on the 03 Acura CL and where is it located?
To replace the EGR valve on a 2003 Acura CL, first, locate it on the rear of the engine, near the intake manifold. Disconnect the negative battery terminal, then remove the vacuum hoses and electrical connector from the EGR valve. Unscrew the mounting bolts and take out the old valve, then install the new valve by reversing the steps. Ensure all connections are secure before reconnecting the battery and starting the engine to check for proper operation.
How can you tell if a valve spring is broken on a 88 Volvo 740 gle?
If you have done a compression check the next step is to take off valve cover and look.
