To change the EGR valve on a 2001 Pontiac Aztek, first, disconnect the negative battery cable and locate the EGR valve, which is typically on the engine near the intake manifold. Remove the electrical connector and the mounting bolts securing the valve, then take out the old valve. Clean the mounting surface to ensure a good seal, install the new EGR valve, and reattach the bolts and connector. Finally, reconnect the battery and start the engine to check for proper operation.
Pontiac Aztek was created in 2001.
Exhaust Gas Recirculation (EGR) Valve Pintle Stuck Open
There are several companies which produce repair manuals for a 2001 Pontiac Aztek. Haynes, Chilton, and the original manufacturer all have service manuals produced for the vehicle.
Try Ebay. I typed in Pontiac Aztek nd all kinds of parts and books for different years come up. Hope this helps
MINECRAFT
number 36
Bottom of the engine on the oil pan.
Normally it means the alternator is defective.
There are two o2 sensors made for the 2001 Pontiac Aztek. Both are located on a exhaust piping of the vehicle. One is closer to the exhaust manifold, while the other is closer to the catalytic converter.
the two bolts, one on each side of the egr valve.
The Pontiac Aztek was considered one of the worst 50 cars of 2001 because of its poor safety performance. More than half of the accidents that occured in the United States of America in 2001 involved Pontiac Azteks because of its faulty breaks and poorly designed air bags.
where is valve cover located on a 2001 Pontiac Grand-Am 4 cyl