answersLogoWhite

0

yes but its better to drop driveshaft

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Is a ford ranger 1998 a front wheel drive or rear wheel drive?

A 1998 Ford Ranger is rear wheel drive ( or 4X4 capable )


Bearing on drive shaft of Camry 1998?

What about it?


How do you disarm an anti-theft system on a 1998 Ford Ranger?

You can disarm your 1998 Ford Ranger antitheft system by removing the antitheft system fuse. The fuse is located in the fuse box.


Where is a 1998 Ford Ranger turn signal relay?

i have a 1998 Ford Ranger xlt 4wheel drive, my turn signals went out. where do i find the flash hazard relay?


Is there any difference between drive shaft in extend cab 1998 S-10 and regular cab 2 part shaft 4cyl 5 speed manual?

A standard cab has a one piece drive shaft.


Can you tow a 1998 ranger 2wd automatic behind a motor home?

You would need to take the drive shaft loose from the rear axle. Any automatic towed over 35 mph for very long will cause the transmission to overheat.


Where is the oil pump drive on a 1998 Ford Ranger with a 4.0 efi engine?

On a 4.0 liter EFI , V6 engine , in a 1998 Ford Ranger : The camshaft position synchronizer located on the top of the engine , near the centerline , at the rear of the engine near the firewall , has a shaft from the bottom that drives the oil pump * From what I understand you can't see the synchronizer with the upper intake manifold installed


How do you replace clutch plate 1998 ford ranger?

To replace the clutch plate on a 1998 Ford Ranger, start by disconnecting the battery and removing the transmission. Support the vehicle securely, then take off the drive shaft, shift linkage, and any necessary exhaust components. Once the transmission is removed, detach the pressure plate and flywheel to access the clutch plate. Replace the old clutch plate with the new one, reassemble all components in reverse order, and ensure everything is properly torqued before reconnecting the battery and testing the clutch.


What drive shaft will fit on passenger side for a 3sge beam engine 1998?

I don't know you tell me.


Is the Oldsmobile Delta 88 1998 a rear wheel drive?

A 1998 Oldsmobile Delta 88 is a rear wheel drive car. This means that a drive shaft runs from the back of the transmission to the rear axle to transfer power.


Where is the oil pump on a 1998 Jeep Wrangler?

Inside the engine oil pan, at the bottom of the distributor drive shaft.Inside the engine oil pan, at the bottom of the distributor drive shaft.


What is the drive shaft wheel nut torque setting on a peugeot 106 1.1 1998?

245 lbs in haynes