0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
When was Motor Transport Corps created?
Motor Transport Corps was created in 1918.
What size are the motor units in the eye?
The motor units of the eye are small. Small motor units are found where precise movements are needed as in the muscles of the eye.
How do you replace the Mazda 626 motor mounts?
Each motor mount is held in place by a retaining bolt. The retaining bolt goes through the middle of the motor mount. Remove the retaining bolt. Jack the engine up. Replace the motor mount.
What is the phone number of the Motor Transport Museum in Campo California?
The phone number of the Motor Transport Museum is: 619-478-2492.
Will a 92 Pontiac transport motor fit in a 97 transport?
=yes it will and hello=
Where is the Motor Transport Museum in Campo California located?
The address of the Motor Transport Museum is: 31949 Highway 94, Campo, CA 91906-3135
What are the Motor mount bolt sizes on a 96 windstar 3.8?
The motor mount bolt size for a 1996 Windstar 3.8 is cross-thread a 3/8" bolt. That is the only bolts that will fit.
How do you install a motor mount on a 1996 Chevrolet Corsica?
Put the new motor mount bushing into the appropriate place. Put the motor mount retaining bolt in. Let the engine down from the jack. Tighten the motor mount bolt.
What is the fastener known as an eye bolt used for?
An eye bolt is a particular type of bolt used to fasten panels to walls among other things. One can purchase these from hardware stores such as Lowes and Bunnings.
How do you change the motor mount front and rear on 1991 Chevrolet Corsica?
Loosen the motor mount retaining bolt. Jack the motor up a few inches. Remove the motor mount retaining bolt and the motor mount bushing. Reverse the process to install the new motor mount.
What is the bolt pattern for a 1996 Pontiac transport?
5 on 115 mm
How do you change motor mount on 1994 Ford Thunderbird?
The 1994 Ford Thunderbird motor mounts are secured with a bolt and nut running through the middle of the motor mount. Loosen the nut and pull the bolt out.
