Yes, provided you computer BIOS (Basic Input Output System) supports it you can upgrade to any amount
PC133 is an SDRAM standard. SDRAM is a type of RAM.
If the label on one RAM chip says "PC133 SDRAM" and the label on another chip says "SDRAM PC133", they are the same thing. There is no different between them. If you want to put more RAM in your computer you first want to check and make sure you have the extra slots necessary. You usually want to get the same kind of RAM that is already in there. So if the existing RAM is PC133, you want to get more PC133 RAM.
One can purchase PC133 SDRAM from a number of stores and online retailers. They can be purchased from Best Buy, eBay, Amazon, PC World and from Target.
There are a lot of places in order for one to find more information about PC133 SDRAM. However, it is strongly suggested that one should check out from the website Amazon.
Yes. It used PC133 SDRAM modules.
Depending on its age, either SDR SDRAM, DDR, or DDR2 RAM.
Macs do have video cards. For example the current range of iMacs have: ▪ 20-inch and 24-inch model with 2.66GHz processor has the NVIDIA GeForce 9400M graphics processor with 256MB of DDR3 SDRAM shared with main memory ▪ 24-inch model with 2.93GHz processor has one of the following: NVIDIA GeForce GT 120 graphics processor with 256MB of GDDR3 memory or NVIDIA GeForce GT 130 graphics processor with 512MB of GDDR3 memory or ATI Radeon HD 4850 graphics processor with 512MB of GDDR3 memory ▪ 24-inch model with 3.06GHz processor has one of the following: NVIDIA GeForce GT 130 graphics processor with 512MB of GDDR3 memory or ATI Radeon HD 4850 graphics processor with 512MB of GDDR3 memory
I do not know which eMac you have... If you have the first, second or third revion then the maximum RAM that you can fit is 1 Gigabyte. However you need SDRAM in the first and second, but DDR SDRAM in the third. If you have the last model (ie: the 1.42Ghz version) then you can upgrade to 2 Gigabytes, through the two expansion slots. The memory modules do not have to be installed in pairs, so you can have 512Mb in one slot and 256Mb in the second to give a total of 768MB, or 512Mb and 1Gb to give a total of 1.5Gb and so on... BUT you have to make sure that the memory module is correct to the eMac. For the 1.42Ghz is: "PC-2700: DDR-SDRAM memory module specified to operate at 166 MHz using DDR-333 chips".
The Intel D845GLLY motherboard supports a maximum of 2GB of PC133 SDRAM, using two 1 GB modules.
In order to upgrade SDRAM with DDR, you will need to replace your motherboard. DDR uses a different slot than SDRAM, so if your motherboard is using SDRAM currently, you will most likely have to replace your motherboard in order to make your system support DDR.
no,you need a new motherboard!
Motherboards of that era would have had a either a combination of the older SDR SDRAM (PC100 or PC133 RAM) and DDR SDRAM, or just DDR SDRAM.For best performance, you would want to use the DDR slots.