no
To find the pressure at the inlet of the evaporator, you subtract the pressure drop from the low side pressure. Given a low side pressure of 15 psig and a pressure drop of 10 psig, the inlet pressure would be 15 psig - 10 psig = 5 psig. Therefore, the pressure at the inlet of the evaporator is 5 psig.
A 16 SEER 3-ton condenser typically draws around 15-20 amps during normal operation. However, the exact amperage can vary depending on factors such as the efficiency of the unit and the specific operating conditions.
15
it depends how cold or warm the condencer is and how long it takes for the water to flow threw it.
12
The expected temperature drop through a direct expansion evaporator coil is typically around 15 to 20 degrees Fahrenheit. This drop in temperature occurs as the refrigerant evaporates and absorbs heat from the air passing over the coil. It is important for efficient cooling and dehumidification in an HVAC system.
Evaporator temp should be 15 Degrees. Gauge pressure should be around 15psig
15*1 to 15*66. Use your calculator to find them.15*1 to 15*66. Use your calculator to find them.15*1 to 15*66. Use your calculator to find them.15*1 to 15*66. Use your calculator to find them.
You can spray a little 409 on the coils, let it sit for 15 to 20 minutes and simply rinse it down from top to bottom. Also rinse it from inside out.
i ents as it passes tthrough the tube to pour out any spare pure liquid from the bacteria and chemicals
The engine may be running hot because of debris between the radiator and the ac condenser.
Use 3: 6/15 = 2/5