Want this question answered?
Could be a Cap coat or a thin coat is sometimes called a skim coat or feather coat
D.scan; skim
I use basic drywall primer over all of those.
They are the same thing. A skim means just a thin finishing coat of plaster about 3mm or so thick, just enough to cover any minor imperferctions on the wall.
SKIM: to go over a block of text quickly to get the main point; SCAN: to search quickly through a block of text for a word or few words
Cut it out then put a skim coat of mud over it.
Lime Based Skim coat (LSC) is made with lime in various formulation and there is no standard formulation. The same consists of mainly lime, oil and several other igredients which changes from place to place. Cement based Skim coat on the other hand is factory made and contains Cement as Binder along with Filler and Additive to support various properties. The basic difference between Lime Based Skim Coat and Cement Based are that the Lime Based Skim Coat are not water resistant and cannot be applied externally, whereas cement based Skim Coat(CSC) can be applied interiors as well as exteriors. They are water resistant. The adhesion strength of the CSC is much higher than LSC. CSC being cement based becomes an integral part of the base plaster hence the durability is very high. LSC on the other hand cannot tolerate any moisture and gets peeled off in contact with the moisture. The Skim Coats are generally done as a base coat for paints and the CSC provide a firm base for the paints. The CSC can be made water resistant which results in lower consumption of Paint by around 20%. The initial cost of application of CSC is slightly higher than the LSC which is compensated by the lesser paint consumption and becomes lower as no primer is required after application of the CSC. For any further information on the properties of the CSC if required I can be contacted in the following email ID: sumonc@adityabirla.com
If you can't solve the seepage problem, the next besrt thing is a water proofing product. Until you are sure you have a tight barrier against moisture, skim coating will be an exercise in futility because it will just bubble up.
Skim the gorund
There are several types of plaster on the market, suitable for different applicatons. Traditionaly, ' Browning' is applied direct to brickwork as an undercoat to the final 'skim' finish coat. Browning is applied up to 12 mm thick with a 2 to 3mm skim over the top. Use 'Multi Finish' as a skim over the Browning, and 'Board Finish as a skim over plaster board sheets. Ensure plaster board sheets are fully taped up prior to skimming, to avoid cracks at the seams.
Skim milk lacks milk fat.
The word skim has only 1 syllable.