Want this question answered?
is it safe to take a bath in rubbing alcohol.
No.
Yes, it is possible.
For gawds sake, don't drink this !!! It will kill YOU!!Consult a doctor. Rubbing alcohol is for external use only. Do not drink it!!
Make sure all the sanding residue is removed. Use soap and water then rinse twice or three times, drying in between. Finally, use a countertop polish specifically meant for corian and apply a lot of it either by hand or with a clean towel wrapped around a sander set at low speed. Wipe off this first coat then spray down the counter with more polish and let soak in for at least 4 hours. Then wipe and buff to a shine.
The following methods are ways to buy a Corian sink: Use online retailers, visit local stores or phone a company who supplies this good to question them about where you could buy a Corian sink.
Yes you can. But wet sand with 1500 grit sand paper prior to using rubbing compound to even out the paint job. This will get rid of imperfections such as orange peel and drips and sags, then after the rubbing compound use a swirl remover for a high gloss shine. I use emamel on alot of my guitars. 20+ years building guitars Stalker Custom Guitars
Use a rubbing compound. This requires a lot of elbow grease or an orbital polisher.
Buff with polishing compound. I use a 2500 grit rubbing compound on mine but it may not be available at the average auto parts store.
There are many different countertop fabrications that Corian offers. You can cusomize your choices and pick exactly what your looking for. You can use this site to help you decide. http://www.scan-top.com/corian.html
ultra fine steel wool for the glass. wax or rubbing compound for the paint ( carefull here test first with compound) I would use 3m finesse.
Well if you just want to clean off the dust you can you compressed air, but if you want to clean off the thermal compound then use rubbing alcohol or acetone.
is it safe to take a bath in rubbing alcohol.
The manufacturer used to recommend "soft scrub".If you've got a bad stain you can use buffing compound available from auto supply stores.If you use something really abrasive, it will take the stain out, but it will eventually end up coming back even worse because of the damage you've done to the finish.
mr. clean magic erasers and water. as per the instructions. that's the best. as for a cleaning soulution, make sure it's not corrosive, caustic, heavily acidic or basic. if it has a boned hand on the label, don't use it. if it's mild enough to touch your hands and not bother you, but is corrosive, make sure you rince well
== == Here is advice: == == * You can use a flitz wheel (brush) on a drill with the polish they send with it or some times you can use a compound polish that you get at your local auto parts store. * Try One Step it does not use abrasives of any type. It is the only product on the market that addresses the problem of oxidation based on the molecular structure of Acrylic Oxidation. It will clear your lens on contact, no sanding or buffing. * About three grits of sandpaper some rubbing compound and some clear coat. * Any time you have to use sandpaper on a headlight you need new lens. Even paper will scratch plastic. Sandpaper and rubbing compound will destroy the clarity.
No do not!!!