There will no issues with the water pump. Most pools don't really use salt water they put salt in the water and have a chlorinator that zaps the salt turning it into Chlorine. Salt is a bit hard on gas heaters though. I like to use heat pumps made out of titanium when I have salt systems in the water.
No
I have a 10 x 30 pool but i don't seem to need a pump and filter!
To keep your swimming pool clean you will need a filters and a water pump. A vacuum would as be a good idea.
form_title= Water Pump form_header= Install a water pump in your home. Do you need to remove an old water pump?*= () Yes () No Are you installing a pool in your home?*= () Yes () No Do you want an energy efficient water pump?*= () Yes () No
You could use your pool pump. or get a submersible pump. it is also not difficult to siphon an above ground pool with a pool vacuum hose. all you need is somewhere to run the water to.
Your pool pump needs to be pushing the water through your solar system
You need a salt water chlorinator. A salt water chlorinator is an electronic devise that converts the salt in the water from the pool into chlorine gas that is then absorbed into the water.
There are just a few easy actions you need to take to get the water from your pump back into the pool. Before anything else, check that the pump is wired in and primed. Make sure there is nothing clogging up the pump basket. Find the pool's water return inlet and proceed to the next step. This is a fixture that is typically installed on the pool's wall. Pool hose of an appropriate length should be attached to the pump's discharge port. The pool's return inlet should be connected to the hose's opposite end. When you're ready, activate the pump. After a while, water should start trickling through the hose and into the pool. Check for leaks in the plumbing and make sure the water is flowing freely. If the water flow rate is too slow or too fast, you can adjust the pump's settings. Proper water circulation and filtration rely on routine pump and pool equipment maintenance.
The most important items you will need are the pool chemicals for maintain the water quality. You will also need a pool vacuum, pump and filters.
A heat pump's name is a bit deceiving, it's just an appliance that heats water. You still need a normal pump and filter combination to move and filter the water.
You should run your pump about 12 hours each day to keep water clean. You can put your pump on a timer to save money. Don't do that until your water clean and clear. If you are still working to get your water just right you need to keep your pump going full time.
A Bilge Pump is what it is referred to on ships when you pump water over board. Trash pump.
how do you hook up the cleaner to salt water pool pump