0
try spraying PB Blaster all over the rotors. We have the same problem, and that did the trick. You need to rent or borrow a 3-jaw puller and start cranking on that, probably while whacking at them with a decent hammer. You'll want to keep your head out of the way too, coz when that all gives way it's gonna come flying off pretty good.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
'How do you remove stuck front brake rotors on a 2003 Jeep Liberty'?
Air tools and PB Blaster.
Removing front brake rotors on 2003 Toyota Tacoma?
how do i remove the brake rotors for a 2003 Toyota tacoma v6 2wd
How to remove and replace front brake rotors on 1999 Nissan frontier?
how to remove front rotors on 2003 Nissan fronter 4 wheel drive pick up
How do you remove front rotors on a 2003 Mazda tribute?
take off a retaining nut?
How do you change front rotor on a jeep liberty 2003?
Check this site, even has nice pictures :) http://www.automedia.com/Replacing/Rotors/ccr20020701rr/1
How do you remove front rotors on a 2003 Hyundai tiburon?
remove brake seats then remove the brake knuckles , then you'll need a wheel hub puller or a slide hammer.
Can the front brake rotors be turned if never done on a ford focus se 2003 with 47276 miles?
Remove the rotors and take them to a machine shop for inspection. If there is not much damage they can be turned.
How do you replaace the rotors from a 2002 Xterra?
2003 Nissan xterra supercharged replace front rotors
How do you remove the front rotors on a 2003 Ford Explorer Sport Trac?
I just replaced mine, rotors had rusted away. Remove caliber, mine were rusted to the wheel hub, had to pry off. cleaned old rust off with steel wool, new rotors slid on with no problem
Which direction does a clutch fan in a 2003 jeep liberty turn to remove?
If you're looking at the car from the front left
What tool do you need to remove the front rotors on a 2003 dodge stratus?
all you need to do is pull hard. if that doesnt work tap the back with a hammer
How do you remove the front rotors from a 2003 Honda Accord?
Most Honda brake rotors require a large slide hammer as they are not only pressed onto the hub, but also rusted which makes it very hard to remove. This may well require an experienced technician.
