Could be a very plugged up fuel filter or catalytic converter.
P1128 TOYOTA - Throttle Control Motor Lock MalfunctionPossible causes, Faulty Throttle Control Motor,Throttle Control Motor harness is open or shorted,Throttle Control Motor circuit poor electrical connection
Your ignition switch has failed. There is a good chance that the wiring plug for the switch has melted slightly due to a blower motor that is pulling too many amps. You will have to replace the switch, plug, and blower motor.
The computer uses a motor in the throttle body assembly to open the throttle plate. There isn't a separate idle air control motor.The computer uses a motor in the throttle body assembly to open the throttle plate. There isn't a separate idle air control motor.
There isn't a separate IAC motor. The electriconic throttle body assembly has a built in motor that opens and closes the throttle plate. The throttle body is not repairable, it must be replaced.
Throttle body has excess carbon build up or bad idle air control motor. Clean throttle body and/or test and replace AIC motor.
The motor chokes at full throttle because either the exhaust valves are bad and cause the motor to loose compression at full throttle or the carb has an air leak.
The throttle position sensor is on the throttle body at the end of the throttle shaft.
by pushing them
The throttle position sensor is on the throttle body.
The blower motor if failing and pulling to much current.The blower motor if failing and pulling to much current.
No
It is located on the outside of the throttle body in line with the butterfly. Remove the air intake from the throttle body and it will be accessable on the back side of the throttle body. Easier to work on if you remove the throttle body. Easier to clean it too.