Car with MM logo 4 door sedan?
Maybach uses the logo seen here
That is Maybach-Motorenbau GmbH, german made automobile
please be more specific ... 8th gen (2008-present): Sedan: 194.1 in (4930 mm) V6 Sedan: 194.3 in (4935 mm) Coupe: 190.9 in (4849 mm) 7th gen (2003-2007): 2003-05 Sedan: 189.5 in (4813 mm) 2003-05 Coupe: 187.6 in (4765 mm) 2006-07 Sedan: 191.1 in (4854 mm) 2006-07 Coupe: 187.8 in (4770 mm) 6th gen (1998-2002): 1998-2000 Sedan: 188.8 in (4796 mm) 2001-02 Sedan: 189.4 in (4811 mm) 1998-2002 Coupe: 186.8 in (4745 mm) 5th gen (94-97)… Read More
Qualcomm's logo has a Q and a MM.
45 mm front and rear for the 17" wheels that came on the G35 Sedan 2003 - 2004 45 mm front and rear for the 17" wheels that came on the G35 Sedan 2003 - 2004
minute maid !
Sedan Only: front 45 mm, rear 45 mm (sport 50mm).
Special bolts! Do not replace with generic will fit bolts! But the head size on my car is 18 MM
m&m maybe? not sure sorry :L
I believe it is a modified Mercedes and costs about 10X the cost of a regular Mercedes
For my 1994 Nissan Sentra SE 4-door 3-speed-automatic FWD sedan, I have the stock 175/70 R13 tires on 4x100mm 13-inch rims (61 mm bore). Over 300 thousand kilometers, and still going strong.
Nissin has 14mm caliper bolts. Akebono has 17 mm caliper bolts and as small logo that has three diamonds similar to a Mitsubishi logo.
1999 Dodge Stratus Sedan Bolt Pattern (in):5x4.00 Bolt Pattern (mm):5x100 Offset Range (mm):40 to 45 Wheel Size Range (in):14x5.5 to 20x7.5 Front Center Bore (mm):57.1 Rear Center Bore (mm):57.1 Stud_Size:12x1.5
The very early Morris Minor was known as the MM. This was the model with a side valve engine,split screen, and the headlamps in the grille. The next model had a small OHV engine, and the headlamps in the wings,but still a split windscreen, it was called series 2. The later style with a one piece windscreen, and a 948cc engine was the first of the Minor 1000's.
According to Wiki, these are the specs.... Production 1948-53; 250,962 producedAssemblyOxford, EnglandBody style2-door saloon, 4-door saloon, 2-door convertibleEngine918 cc (0.918 l) Morris Sidevalve engine I428hpWheelbase86 in (2,184 mm)Length148 in (3,759 mm
check how much your feet is in mm or cm then plus that several of times to get to the other end of the door
Door heights can vary. Checking out a local DIY website shows doors with heights: 1950 mm = 195.0 cm ≈ 76.8 in = 6ft 4.8 in 1981 mm = 198.1 cm ≈ 78.0 in = 6 ft 6 in 2032 mm = 203.2 cm = 80.0 in = 6 ft 8 in 2040 mm = 204.0 cm ≈ 80.3 in = 6 ft 8.3 in
1,000 mm = 1 meter 1,981 mm = 1.981 meter 686 mm = 0.686 meter 1.981 x 0.686 = 1.358966 square meters
They vary a bit from model to model but the dimensions of the 3-door Mini Cooper-S arelength = 3714 mm, height = 1407 mm and width = 1913 mm.
max height 950 mm max width1800 mm with tires
A lock on a door knob.
1.23 metres = 1,230 millimetres
How hard is it to take front brake rotor on 96 Honda accord ex 4 door sedan What parts do you have to take out besides brake caliber and pads?
you have 10 or 12 mm bolt one on top and one bottom of caliber take a big screw driver push back piston off pads that releases pressure then pop pads out put new ones in
Full-size cars are usually denoted for their length, nearing 5,000 mm (197 in) in basic sedans, with luxury models often tending to reach 5,350 mm (211 in). Previously, a wheelbase greater than 2,790 mm (110 in) was the criterion. The term first appeared in the early 1960s to distinguish what also became known as "standard"-size cars from the new compact and intermediate models then being introduced. Full-size is also defined in space measurement as greater… Read More
height=20.2 cm width=needs info
not unless the door has come off its hinges and fallen over
The Volkswagen Golf 4 has a 2.0 litre turbo G T I. The width is 1735 mm. The length is around 4148 mm. The height is 1440 mm. The wheelbase is 2512 mm.
about 5000 thousand mm.
The front door speakers in a 2004 Volkswagen Polo measure 6.7 inches. This is equal to about 170 mm or 17 cm.
The W450 Smart For two is 59.6 inches or 1,510 mm wide, the W451 is 61.4 inches or 1,560 mm wide, and the W453 is 65.5 inches or 1,663 mm wide.
inches or MM, depending on the country.
A typical car will be in the region of 4635mm long, 1800 mm wide and 950mm high.
It will not take long at all to remove door trim from a Renault Menage. All you have to do is remove the bottom 10 mm bolts on the door, un-clip the door lights, undo the plastic trimming from the clips, unscrew the door cover and then remove all trimming.
In any car don't let go less than 2 - 3 mm
mm, cm or m.
The interior height of the threshold to a front door should not cross 20 mm, so it is its ceiling. The rest depends on other parameters such as for instance type of the construction
dekameter. a car would be about .39 of a dekameter in length, as opposed to thousands of mm
um-mm I'm not sure how to answer this .... but its because it's a machine?
Unfortunately, you will have to remove the door panel to gain access to the latch assembly. I am actually going through this right now. Remove the door pull (where the power window switches are), the trim around the door handle, either the factory tweeter or the trim by the outside mirror, the speaker, then the 3 screws in the speaker area that hold the door panel to the door. Now, gently pull the bottom center… Read More
There is no proper or set distance from the doorway. When roughing in a house the distance is determined on where the door framing is located and how close the next adjoining stud is. If the adjacent stud is too far away then the carpenter can install some bridging between the studs to locate the switch junction box on. Try to keep it from 150 to 300 mm, (6 to 12 inches) from the rough… Read More
Most metal pipes thickness are 25 mm
REMOVE A DOOR LOCK ASSY. ON A HONDA first of all what year is the Honda and is the lock on the handle or on the door. if the lock is in the door you have to remove the interior door panel. you have to take pff the plastic housing around the inner handle with a Phillips screw drive and then pop the clips away from the door when you do this you may have… Read More
Car tire rims are measured in inches and or (mm)Millimeters. It usually depends if it is an american car or not. All none american and some american newer cars are in MM, older american cars/trucks are usually inches. Using Millimeters is more accurate since the increments are smaller. Example: 7inches =177.8mm
From the IRC 2003 Code: 311.4.3 Landings at doors. There shall be a floor or landing on each side of each exterior door. Exception: Where a stairway of two or fewer risers is located on the exterior side of a door, other than the required exit door, a landing is not required for the exterior side of the door he floor or landing at the exit door required by Section R311.4.1 shall not be more… Read More
A Typical F1 car in the 2010 season would be 4635 mm long, 1800 mm wide and 950 mm tall. The measurements in centimetres is: Length - 463.5 cm, Width - 180 cm, and height 95 cm. All the F1 cars in the grid from all the 12 teams are governed by the rules laid out by the F1 administration and follow these sizes only.
Meters/MM in Non US countries, Inches in the US.
Is it ok to patch leather armrest that has two 5 mm punctures if you want the repair to last as long as the car and the car is new?
you can patch it, but if it was me i would go to a junk yard and find a car like yours and take it off that car
245 MM and 305 MM would mean the car won't run Do not use 25.4 MM adjusting a valve this tight may lead to engine damage 30.5 MM might be close enough but there should be a guide to tell you how much you can be off on the measurement EG: 30MM + or - 1 MM
In Australia, standard door height is 2040 mm. Before we changed to metric units, it used to be 6 ft 8 inches. Go to your local hardware store or building supplier, and measure one yourself. The shop assistant will most likely know the height, and won't need to measure it. It is a standard height which is used all over the entire nation.