0
Caused by excessive pressure from overlying structures over a cavern?
Wiki User
∙ 11y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Air pressure is caused by?
air pressure is caused by the constant motion of air molecules
Caused by collisions with container walls?
gas pressure
Permanent wrinkling of skin is usually due to changes caused by excessive exposure to?
Sunlight
Are storms often caused by low air pressure or high air pressure?
low air pressure because it said in the book general science that almost all stors are caused by low air pressure.
Folding and faulting are caused by?
Mountains
What the following can be caused by excessive pressure from overlying structures over a cavern?
sinkholes
Which of the following can be caused by excessive pressure from overlying structures over a cavern?
sinkholes
Excessive heat buildup in a tire is caused by?
Low air pressure.
Which is an indicator of a leak in a high pressure system?
Excessive superheat, caused by a low refrigerant charge.
Excessive or uneven tire wear can be caused by faults in which THREE what?
tire air pressure, worn/damaged steering linkage, alignment,
Why is my grand am using excessive water?
excessive water usage (as in it's always low) is usually caused by a crack somewhere in the coolant galleries. you can take it to a shop and get a pressure check on the cooling system.
What would cause excessive wear to the tires in suspention system?
Normally caused by an alignment problem. Have the vehicle aligned properly at a trusted tire shop. Can also be caused by incorrect air pressure in the tires. Inflate to manufactures recommended pressure and not the pressure listed on the tire sidewall which is the maximum pressure the tire can safely handle.
What is the defects that take place in deep drawing?
In deep drawing process the following defects may occur: 1. Wrinkles - caused due to excessive clearance between the punch and die. also caused due to improper pressure pad pressure and die and punch radii, 2. Ruptures - caused by incorrect draw ratio another reason is improper die and punch radii, 3. Excess thinning of the cup wall - caused by incorrect die and punch clearance and radii and also excessive pressure by pressure pad. These are the most typical defects. Hope the above helps.... Keshav Udipi
What make oil cap blow off?
Normally caused by excessive crankcase pressure. A blocked breather or bad piston rings are the likely causes.
What are the possible causes for oil pressure to drop very low on a 1995 Pontiac Bonneville?
Low oil pressure can be caused by a number of problems, including inaccurate gauge or sending unit; thin oil due to poor oil quality; excessive oil pressure; broken oil pressure relief spring; oil inlet tube restriction or leak; or excessive oil pump or camshaft clearance.
What will cause a marine air compressor high pressure relief valve to lift?
Excessive pressure in the compressor, after the first stage (or how ever many stages there are). Excessive pressure could be caused by shut/ blocked discharge valve. There will also be a relief valve fitted to the intercooler, should one of the tubes burst. This would let air into the water side and suddenly increase the pressure in the intercooler, so a relief valve is fitted.
Acne is caused by excessive secretion from what glands?
sebaceous
