Buick LeSabre

Change a water pump on a 1997 Buick LeSabre V6 engine?

567

Top Answer
User Avatar
Wiki User
Answered
2009-12-14 17:10:24
2009-12-14 17:10:24

hi my car is leaking from the water pump so what can i do to stop leak ? and if i need to change the water pump would you guys tell me how can i change it?
my car is 1997 Buick LeSabre v6 engine

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions





It's located on the block, just above the water pump


Temperature sensor switch on the Buick LeSabre where is it located


The thermostat on a 1992 LeSabre should be inside of the top radiator hose inlet. You can easily change it by removing the top hose and water inlet.



if it's not raining, the heater core is leaking


https://www.youtube.com/watch?v=Xaz_tGOyhlw



Leaking from? Hose Water pump Intake gasket


Faulty sending unit or shorted wire Worn engine bearings Sludged or defective oil pump Gasoline or water in oil


replace the water heater inlet pipe on the intake manifold on a 3800


I have water leaking into a 1997 Buick LeSabre problem. I cannot find where it comes into the car. It pools in the rear passenger seat driver's side floor. It can happen even while the car is parked.



it should be behind the water pump pulley on the lower left side when looking at it from the side of the car.


3800 II V-6LONG Bolts - 2 Steps: 15FtLbs; +40degSHORT Bolts - 2 Steps: 11FtLbs; +80deg


Drain the radiator and dispose of the coolant as it is toxic to animals. Remove the top radiator hose. Remove the water inlet. Pull the thermostat from under the inlet, and replace. Reverse the procedure to finish the instillation.


Drain the radiator. Remove the LeSabre's top radiator hose. Unbolt the engine water inlet and remove to reach the thermostat. Pull the thermostat out and slide in the new one. Reinstall the inlet and hose before filling the system with new coolant.


My 90 lesabre did the same thing. When it cut off after driving I sprayed water on the crank sensor and it started right back up. A buick mechanic told me to do this and this is how I found out the crank sensor was bad!


unless your comfortable jacking up the engine, take it to a shop. call around for best price. Dealer wants about $350 for it all. while your waiting for the shop to fix it, buy a new serpentine belt and have them replace it also



Yeah, that's it!!!!! Have the engine running while you replace the water pump.... This kind of question is a good example of why children are taught NOT to eat paste.


The location of a water pump on a 1995 Buick Skylark 4 cylinder is next to the engine. It is found directly under the alternator.


does it have air conditioning? if it does, the water is just condensation dripping off of some ofthe air conditioning components. its completely normal



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.