0
Is jacking up the engine the only way to remove the water pump on a 1995 buick LeSabre?
Wiki User
∙ 14y ago
Yes, you have to loosen engine mount
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the ecu located on a 1995 Buick lesabre?
where is the engine controle module located in a 1995 buick lesabre
Change struts in 1998 buick lesabre?
Struts on a 1998 Buick LeSabre are changed by jacking the vehicle up, removing the wheel, and unbolting the strut. It can then be pulled from its mounts and a new strut put in place.
Where is the solenoid on 1998 Buick lesabre?
The 1998 Buick LeSabre solenoid can be found on the firewall in the engine compartment. There will be three solenoids on the firewall.
How do you replace the alternator on a 1992 Buick LeSabre?
If it is the same 3800 engine as the 1993 Lesabre--very simple. Alternator is right on top of the engine. Loosen the serpentine belt ( tensioner) - remove the mounting bolts that hold the alternator on the bracket- remove the wire connections.
1994 custom buick lesabre starter bolts unreachable how to raise engine to remove starter?
where are the two bolts located on the starter?
Does 1992 Buick lesabre have timing chain or timing belt?
The 3.8 litre V6 engine in a 1992 Buick LeSabre has a timing CHAIN
How do you remove rear bumper cover for a 2000 Buick Lesabre?
,
Is there a diagram of the engine of a 2003 Buick leSabre limited?
Thanks
How do you remove a battery from a 2002 buick lesabre?
its under the back seat
Where is the starter on a 1989 Buick Lesabre?
The starter on a 1989 Buick LeSabre can be found on the driver's side of the engine. It is down low, back by the bell housing for the transmission.
How to replace Alternator on 97 buick lesabre?
Remove the positive cable from your 1997 Buick LeSabre battery. Remove the alternator belt. Remove the alternator wiring harness. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
How do you install the serpentine belt on a 1998 Buick Lesabre 3800 transverse-mounted engine--procedures for removing the front engine mount?
Remove the lower bolt on the engine mount housing, then remove the spacer. The belt will slip right through.
