how to replas spark plugs for suzuki wagon r
the spark plugs r on top of motor.if u don't no that u should prob jus pay a shop to do the job. its like 50 bucks if that its a eazy job. PS don't overtighten:{
the R stands for Resistor. It is a resistor plug.
Ac r 45s
well first of all you have to remove the black cover on your engine..... it will have writing on it ex: ectech 2.2. you will need to remober the throttle wire off the clip and remove the clip... after that there will be 4 10mm bolts on the cover... remove them... you will need to pull the cover off.After that u will c the plug wires and the plugs... the plugs r 5/8..
I believe ngk r the best....
Assuming the engine is the 3100 or 3.1 ltr V6 ? Note any radio codes remove the battery ground strap remove the alternator Now it's possible to r&r the plugs by reaching through where the alternator lives. On the 2000 LeSabre, (3800/3.8L V6) there is no easy way. It is a mechanic's nightmare and the original plugs were installed before the engine was installed. That is why they used AC Delco Iridium 100,000 mile spark plugs.
take off plastic cover plugs and coil packs r located there
The gap for NGK-R CR9E PLUGS 31-35
Drill a hole in the driver's side wheel well to get to the difficult spark plug. In order for it not to be visible, drill the hole high enough to both be hidden and reach the hard to get spark plug with a long extension. I lift and support the front end and remove the front tires. Using a spark plug socket with a long wobble extension you can reach under the rubber splash guard and r&r the spark plugs with ease.
C. R. Hinings has written: 'The dynamics of strategic change' -- subject(s): Case studies, Organizational change
The passenger side spark plugs are accessed by removing the R/F tire and inner fender well. Make sure to place vehicle on a (jack stand, in park, chock the rear tire) and not just the jack. With the inner fender liner removed, you will be able to see the spark plugs. Gap is .052-.056" 13lb-ft of torque.