The PCV valve is located at the end of a short, rubber hose that enters the intake manifold in the back of the engineand on the drivers side. It is near the last "N" in Nisson that is imprinted into the intake manifold. It takes a 3/4" wrench to remove it. THANKKS GREAT HELP SAME PLACE ON MY 2002 Nissan TOP OF ENGINE - DRIVERS SIDE ON THE SIDE BY THE LAST "N".
yes. it is located on a crossmember behind the rear axle. you must remove the spare tire to get to it.
Which fuse box are you refering to. The one inside the cab or under the hood?
4cyl back of intake near throttle body// 6cyl roughly same area
where is the temp. sending unit located on a 1999 ford ranger xlt 6cyl 3.0l .Gauge does not work.
map sensor 2000 malibu location
If it is the 2.4 (4cyl) or 3.5 (6cyl) it is behind the timing belt. If it is a 2.7 (6cyl) it is located on the engine near the bellhousing, bank two side (side facing radiator)
your fuel pump is located in the top rear of the fuel tank
4.5 quarts for 6cyl and 5 quarts for ecotek 4cyl!
behind the glove box
Probably in the fuel tank
Yes, that should work just fine, they are both YJ's and 6 cylinders so all should match.
2,300 lbs for the 4 cyl engine and 5,000 lbs for the 6cyl
it is located between the air filter and the brake fluid container. look in between the the gap of those two. this is good for the 4cyl version. not sure if its the same in the 6cyl. it is well worth the 60$ or whatever to take it to the dealer and have them do it.
It does not have a Mass Airflow Sensor.
The solenoid is located on the passenger side on top of the starter motor.
on the intake manifold under the plastic cover on top
The camshaft position sensor on a 4.3L engine would be in the distributor.
remove the alternator and bracket it is under the bracket
where is the computer on 1988 ford econoline 300 6cyl
There isn't one. The distributor is synched to zero degrees with a scan tool, it can not be done with a timing light.
It is located on the left side of the engine (6cyl) next to the thermostat, in order to replace both thermostat or sensor the alternator needs to be removed