Want this question answered?
You cannot replace the headlight bulb. You need to buy a new headlight unit.
AnswerThis code is related to the sensor switch on the Air Intake Unit. Check your cable under the hood of the car, make sure it is plugged in, when it is, clear the code and start the engine. The code should be gone. If the problem persists then you might have to replace the cable Owner of a Daewoo Nubira SE
The light means low oil pressure. It can be you installed the wrong filter or the filter is defective. It can mean the oil pressure sending unit is defective and it can also mean the oil pump is failing.
undo all 3 11mm bolts on headlight case. . Unplug the 2 plugs on back of headlight. . ull feel a button "clip" that when pushed lets u disconnect the cables. . u can do this after wrigling out the headlight abit. . . Once the unit is out unscrew that big cap. . unclip headlight socket and take out headlight and DO NOT TOUCH!! unleas its broken and u dont want to keep it. . Insert new headlight into the socket and clip back in (make sure its clean though!!) Wriggle headlight unit back in place PATIENTLY. . no easy way of explaining of how to get the b***h back on really easily
Replace the rocker switch unit in the door. Usually about $10-$15 from wreckers. Common effect is window will go down but no up...(Burnout of switch unit.) Will master on drivers door work window?? If yes, then above is the problem...
There are two bolts holding the unit to the vehicle. Open the hood, look down on the headlight unit, and you will see the two bolt heads. Remove the two bolts, one will be long the other short. Then pull the headlight unit from the car. You will need to disconnect the the headlight wiring if you are benching the unit.
Open the hood and right behind the headlight unit you will see two clips...just pull them up and the headlight unit comes right out.
To remove the headlight unit from Vauxhall Vectra SRI 1999, first remove the cover and disconnect the wires by pulling outwards. Push each side of the pin outwards until it releases. Then remove the headlight unit.
I found by trial and error the easy way is to take out the headlight bulb and push out the sidelight bulb and holder. Pull the old bulb out and replace then put it all back in reverse order. It is possibly easier to remove headlight from the car which is easily done by removing body coloured trim under the headlight then remove three ten mm bolts,detach wiring and lift unit away.
There aren't headlight covers, it all one unit. One of my lens was cracked and I had to replace the whole unit.
Open hood. twist headlight to remove. Unplug old unit. Using gloves to prevent bodily fluids on new unit, remove new unit from pkg and plug in wiring harness. Re-install new unit twisting it to secure and lock in headlight housing.
To remove the headlight on the mx-3 you must unbolt the front bumper, loosen all 4? bolts and disconnect the headlight wiring. The whole unit should just pull right off.