0
Check engine light came on in a 2001 ford ranger xlt to change PCV valve had it changed but didn't have any of the sensors etc that were connected to it changed how do you keep it off?
Wiki User
∙ 17y ago
I've never heard of an OBDII code that would tell you to change a PCV valve. What code is it?
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
What sensors are connected to the throttle body of a 3.4L engine?
The only sensors that I am aware of on the throttle body is the throttle position sensor.
What are the sensors connected to the check engine light on a 1995 silverado?
Every sensor on the engine and transmission can cause the light to come on.
What if the check engine light is on after you have changed all the sensors?
Then you may want to have a mechanic check it out.
Will a Dodge Neon engine fit in a Plymouth Breeze?
yes, they are the same engine. however the neons changed the electrical connectors in 1997 so if your breeze is 97 or up then try to get a neon motor from 97 or up. if you cant, then you will have to change all the sensors.
What sensors fuel system components should be replaced to get back to the highest fuel economy on a 1990 Geo Metro XFI?
first up i would replace air filter and fuel filter then get engine tune up if nothing has been changed on vehicle, you should not have to change sensors
How do you change the air filter on a 2.2L 2006 chev HHR?
The air filter is in the air box on top of the engine. Disconnect the air intake from the fender, then the wiring to the sensors. The box can now be removed and the filter changed.
Where is the engine block of a 1999 Lexus rx 300 and do I need to take the engine block to replace the knock sensors?
Your engine block is the main part of your engine that holds the crankshaft and pistons internally. Your knock sensors, there are two, are screwed into the top of the engine block in the valley between the cylinder heads. You don't have to remove the engine block, you do have to remove the upper and lower intake manifolds to get to them. I changed the sensors in my 99 rx300, long day!
Changed all oxygen sensors on 1997 ford explorer but still reading samething?
Don't know what your original reading was, but the O2 sensors before the cats moniter how the engine is running and the O2 sensors after the cats moniter how the cats are performing.
What do you check when you have codes p1071 and p1074 on a 98 Ford Windstar bank1 and bank2 are lean - changed the PVC and maf?
Change the downstream o2 sensors. Does the engine run ok? Does it seem to lean? It could also be the upstream sensors so beware.Look for vacuum leaks.Also review the "Related Questions" below
Do you need to change both oxygen sensors on 2004 Lancer?
no just the precat as the latter does not really change or affect how the engine runs
What sensors are needed to be changed out from 95 ciera model three one L v6 engine to match back the original 95 supreme three one L v6 engine so the original engine harness fits the ciera engine?
Sensors needed to be changed out from 95 ciera model three one L V6 engine to match back the original 95 supereme three L6 engine are Ciera Knock Sensor and Soeedometer Sensor.
How many sensors are connected to the check engine light?
Upwards of 50 to 100. Depends on Year, Make, Model.......... See related questions below.
