Can you replace your 2000 Camry CE 4-cylinder engine with a 1997 Camry engine?"
It depends on brand of sensor as well as type of engine (4 cylinder vs. V6). It can be anywhere in between $60-150 depending on brand.
I am not sure but I think you have to replace the oxygen sensor. Hope this help.
Autozone, pep boys, car part(in philadelphia)
tell me how to do it
The ECT or the Engine Coolant Temperature Sensor is a switch. This switch is located on the bottom of the radiator in the 1996 Camry.
How do i replace mass air flow sensor 1992 lexus es 300
Replace the bulb that is burnt out.
The 2003 Toyota Camry coolant temperature sensor can be found on top of the engine. The coolant temperature sensor will be near the center of the exhaust manifold.
There are thousands of reasons. You need to pull out error codes. You can do it at local autozone store.
The coolant temp sensor for a 1977 Camry is important to the engine running properly. The sensor sends a signal to the computer to keep the air/ fuel mix correct.
Knock sensor is located on the side of the engine facing the firewall. There is only one sensor at that side.
V 6 300
Disconnect the battery for couple minutes, or stop by AutoZone, they can erase it for you for free.
The air flow sensor is located inside the air box of a 1998 Toyota Camry LE. To replace the unit the air box screws must be unmounted and the sensor disconnected.
The intake air temperature sensor is located on top of the intake. In a 1990 Toyota Camry the air temp sensor assures the ECU the engine is running at optimal temperature.
It depends on which of the. Camry 1999 LE has two of them. One is next to the engine, another one is under the passenger seat. You get in AutoZone a special oxygen sensor wrench, I highly recommend to use because it's to brake the sensor. While the engine is still warm, disconnect the battery, disconnect the oxygen sendor from the wire harness. Remove the sensor using the wrench, be careful it can be hot. Install a new sensor, thighten it, connect to the harness. If you need to replace the sensor under the passenger seat, you will have remove the seat, if you want to disconnect it. Juck your car up. After that remove the sensor (you can find it in the exhaust pipe just under the passenger seat) using the wrench, install a new one, tighten it, connect the sensor to the harnees. Connect the battery.
Knock sensor is attached to the engine side facing the firewall. It's not easy to reach.
Trouble code P0500 means: Vehicle Speed Sensor 'A' Replace the speed sensor
It's on the back of the engine, left side. (O2 rear sensor)
You can replace a four-cylinder Toyota Camry engine with a six-cylinder engine. You will need to purchase a motor mount adapter kit. There will be an extensive amount of work.
It should be in the side of the engine facing the firewall.
You can find it in the exhaust manifold, it's visible from the engine compartment. Basically it's between the engine radiator.
you go to the Toyota place