If the check engine light stays on for the Nissan Pulsar n16, you would need to check the engine in order to clear codes. You can take the car for service and the problem will be diagnosed and restored to normalcy.
After reading the code, fixing the cause, you clear the code with a scan tool.
if your take it to a autozone tell them you have a check engine light and they will tell you whats wrong if anything and reset it take it to autozone and tell them your check engine light is on and they should reset it
Trying to clear the check engine light in a Kia Sorento yourself is not recommended. The check engine light could indicate a serious problem and the car should be inspected by someone qualified.
Use a code reader/scanner and clear all codes or try disconnecting the negative battery terminal for up to 30 mins then reconnect
I clear the check engine light with a Scangauge II. But most ODB-II devices can read and clear the code.
GO TO A AUT ZONE TELL THEM THE CHECK ENGINE LIGHT IS ON THEY WILL COME OUT AND HOOK SOMTHING UP TO IT . THEY WILL GIVE YOU A LIST OF WHAT COULD BE THE PROBLEM AND ASK THEM TO CLEAR IT, THEY WILL DO ALL THIS FOR FREE- HOPE THIS HELPS- AMBER
After repairing the cause of the code, you clear the code with a scan tool.
You can disconnect the battery for about 5 minutes and this will clear the check engine codes stored in the computer. If the problem that caused the code has not been repaired the check engine code will just happen again. The only way to get the check engine light to not be on is to repair the problem then clear the codes.
Take it to advanced auto parts and have them clear the codes ... its free.
You use the test monitor and scroll down to clear code
A scan tool is required to clear the check engine light. If the failure is not repaired, the light will return.
No, a person cannot just clean a check engine light to pass inspection. The issue causing the check engine light must be dealt with and fixed.