It's in a real bad place. Above the oil filter, below the power steering pump, above the air conditioning compressor with about a 1/2 inch around it. If your light comes on intermittently Have a shop replace it cost me 13 dollars for switch I spent 3 hours trying to get to it in the wheel well gave up took it to a shop they said wait for it only take a few min. 3 1/2 hours later they finished best 64 dollars I have spent
It is between the heads, under the lower intake manifold.
The crankshaft position sensor on a 3.5L Chrysler Pacifica is located next to the motor, toward the rear. It can be found next to the transmission.
Low tire pressure or failed tire pressure sensor.Low tire pressure or failed tire pressure sensor.
If your tpms indicator is on in your Chrysler Pacifica and you have already fixed the tire pressure issue, simply continue driving a few miles and the sensor will reset itself. It usually only takes about 4 miles to reset it.
Around the oil filter location
It doesn't have a mass air flow sensor.
You will require a "magnetic doughnut" from your local dealership. It goes over the tire stem, then you retrain the pressure sensors though the computer prompts.
No Camshaft Position Sensor Circuit Failure
There are two on the trans and one at each wheel bearing.
No, the sensor will need replaced.
There are two on the trasnmission and one at each wheel bearing.
It is on the valve body, inside the transmission.