If the Chrysler Voyager key alarm will not go off and the key fob has new batteries, it is possible that the key fob needs to be repaired. Sometimes, the battery holder needs to be re-soldered into the circuit board. It may also need to be reprogrammed by putting it in the ignition and turning it off and on several times, then start the vehicle.
Try replacing the batteries
The dealer "flashes" the computer to correct software issues.
Remember batteries with memories? You had to go through all the nonsense of completely discharging then recharging your batteries or your battery developed a memory. After a while you only got half the use from your battery. Batteries are too expensive for that nonsense. Get AA lithium batteries and get full power from them first time and every time. Lithium batteries are especially important for high power items like cameras and flashes.
Could be just about anything without more information. Check your oil level first.
When you lock the doors, there will be a small red light on the dash that flashes to tell you the alarm is arming.
Try taking battery terminal off car and back on again it worked for me with crashed Clio
There is a problem with the SRS system. Take it to the dealer for immediate service. Do not atttempt to repair this yourself. This is not a DIY repair.
That means it dosent have to be charged anymoreWhen you start to charge and the red light flashes for a while, then it changes from red to green alternate flashing this means that the actual batteries doing the charging are not fully charged. Either buy new batteries or make sure you charging batteries are fully charged before you attempt to charge it
flashes of light
32 and 2132 and 21
One main reason for hot flashes is menopause. Only a doctor can diagnose the cause of hot flashes.
If check engine is on while driving but not flashing the computer of the car is sending out a code you probably have an emission problem count the flashes this will give you a code. a short pause between the flashes is the second or third, forth, etc of the code. after a long pause it will either repeat the code or give u another.