answersLogoWhite

0


Best Answer

Not really. This sounds like a bad ground on the battery or the regulator.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Could a worn out belt tensioner cause pulsating lights?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What could cause pulsating pain in the upper left quadrant of the stomach?

An aortic aneurysm can cause this.


Would a bad water pump cause the tensioner to vibrate loose pulling the alternator belt off in a front wheel drive '87 Pontiac Grand Am 2.5l?

It could cause it. It could be something else though. It could also be a worn-out tensioner.


Could improper torque on lug nuts cause pulsating pedal?

No it will not, The front brake rotors are out of round. Needs replaced are turned, both rotors.


What would cause your van to make a pulsating sound while its idling?

Check your cooling fan motor. If it is no good when it goes on it will make a pulsating sound.


Could the ignition on a Trailblazer cause head lights not to work properly?

Yes, the ignition on a trailblazer can cause head lights to work improperly.


Can sore neck muscles cause occasional dizziness and pulsating tinnitus?

yes absolutely!


What does a cam chain tensioner do?

A cam chain tensioner puts pressure on the chain, keeping it taut. If the chain were to not be tight, then it could slip on the gears causing the engine to run rough, or cause engine damage.


Cause of pulsating brakes?

Rotors may be out of "round" (lateral runout) and need to be resurfaced or replaced


What could cause the bottom brake lights on 1998 Explorer to be out while the dash lights and backup lights work?

Blown fuse or defective brake light switch.


Would a bad dimmer switch cause head lights not to work?

Yes, it could.


What can cause all the lights on the dash to come on and then go off while the vehicle is running?

it could be a faulty alternator bring on all lights


Why do my rear lights not work?

Could have a short in your wire, a bare wire touching bare metal could cause it to ground out.