Yes with fabricating, saw it done and looked good.
Yes
250hp @ the crank
14mm open end wrench
i have a 92 sc400. the cabin fuse box is on the drivers side towards the pedal on the drivers door jam. its small box so look hard.
It's under the dash, on passenger side, all the way under where your feet would be next to fire wall.
The 1993 Lexus SC400 uses R-12 refrigerant for its air conditioning system. However, R-12 is no longer produced and is considered a controlled substance due to its environmental impact. Many owners choose to retrofit their systems to use R-134a, which is more environmentally friendly. If considering a retrofit, it's important to ensure that the system is properly converted to avoid damage.
To change the starter on a 1993 Lexus SC400, first disconnect the negative battery terminal to ensure safety. Then, remove the intake manifold or necessary components to access the starter, which is located on the passenger side of the engine. Unscrew the mounting bolts holding the starter in place, disconnect the electrical connections, and then replace it with the new starter. Finally, reassemble the components, reconnect the battery, and test the new starter.
1 bolt on top of light. 2 bolts behind fender. remove dust cover in wheel well to reach fender bolts.
On a 1993 Lexus SC400, the timing marks are located on the crankshaft pulley and the timing belt cover. You can find the marks on the crankshaft pulley aligned with a mark on the timing belt cover, indicating the correct alignment for the engine's timing. It’s important to ensure that the engine is at TDC (Top Dead Center) for cylinder one when checking these marks. Always consult the vehicle's service manual for specific details and diagrams.
The spark plug wire diagram for a 1993 Lexus SC400 typically shows the ignition coil connections to the spark plugs, with each wire labeled according to its cylinder number. The firing order for the SC400's 4.0L V8 engine is 1-8-4-3-6-5-7-2, meaning the first cylinder is at the front of the engine on the driver's side. It's essential to ensure that each wire is connected to the correct cylinder to maintain proper engine function. For accurate wiring diagrams, refer to a service manual specific to the SC400 or consult a professional mechanic.
To remove the automatic shifter on a 1993 Lexus SC400, you'll first need to disconnect the battery to avoid any electrical issues. Then, remove the center console trim by carefully prying it up, which may involve unscrewing some screws. Once the trim is off, locate the shift lever retaining bolt, remove it, and disconnect any electrical connectors. Finally, you can pull the shifter out from its housing.
toyota t IV