answersLogoWhite

0


Best Answer

Yes. Try .045".

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Could you set the plug gap higher than 35 in a 1978 Chevy 350?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is spark plug gap for 1978 Chevy 454?

0.045


What is the proper spark plug gap for a stock 1978 Chevy 350?

.060


What is the spark plug gap for 1978 Chevy 350?

35 thousands of an inch.


Where is number one plug wire on your 1978 Chevy?

On the Chevy V8 it is on the front of the engine driver's side. On a inline 6 cylinder it is the plug on the front of the engine. On the V6 it is the front plug on the passenger side.


What is the Spark plug gap on a 1978 Chevy 305?

.045 inch , according to my Chilton book


Why does 1997 Chevy Blazer miss out when you accelerate?

Could be a faulty spark plug or spark plug wire.


What is the spark plug gap on a 1978 Chevy Blazer?

Look in your owner's manual and under the hood on a placard and you will find the answer to this question.


Chevy s-10 engine coolant leaking from block?

Could be a freez out plug you need to find out where it's coming from and see if there is a plug there. If so then you need to replace this plug.


Why does older 1995 Chevy 3500 idle and rev fine but skip during accelerating?

Could be a faulty spark plug or spark plug wire.


Spark plug gap on a 1978 Chevy 350?

(HD Calif ) PLUG type R44TX A/C Delco. GAP-0.060 That's the heavy duty engine. (The FED) Plug type R44t .......................Gap-0.040 This covers 49 different states.


Where is the manual transmission plug for 1992 Chevy ck1500?

If you look at the side of the transmission, you will see two plugs that look the same. But one will be towards the bottom real low, that will be the drain plug. The higher plug will be the fill plug and it will be 4-5 inches above the lower plug.


Why is 1986 Chevy s-10 idle smooth and miss when driven?

You could have a spark plug wire going bad. When idling it has the lowest demand, and when put under a load, higher resistance causes it to hunt a ground with the least resistance which may not be through the spark plug, therefore causing a misfire.