what is the specification of the cram shaft of sunfire 1998, motor 2.4
The throttle position sensor is on the throttle shaft, on the throttle body.
how to check fuse for horn in a 1998 Pontiac sunfire
You might as well take the motor our, its a pain in the a**. the thermostat is between the motor and the firewall and above the transmission...NOT fun. I replaced mine when I had to rebuild the motor due to a broken writs pin :(
The crank shaft sensor on a 1998 BMW 74Oil is located down near the crank on the front of a motor. It is super easy to replace but sometimes reaching the harness wire is a little bit difficult.
Warning:Always disable the airbag system before working in the vacinity of the impact sensors,steering column or instrument panel * Remove the lower right dash insulator panel below the glove box for access to the blower motor * Disconnect the electrical connector from the blower motor and remove the three screws from the blower motor housing * Pull the motor and fan straight down * To remove the fan from the blower motor use a narrow punch and tap the shaft out of the fan assembly * Install the fan onto the new motor
It sounds as if you have either a power or ground problem at the motor.
Check the recall on the problem with the power steering pinion shaft....maybe what u need instead recall #02v286000 (try motor trend.com or google it)
To the best of my knowledge, this is no carburetor on any Sunfire. I believe that they were all fuel injected.
the 98 sunfire haz a 57.2 litre gas tank
Dead short in either wiring or wiper motor Disconnect wiring harness to motor and install fuse--if it continue to "blow" problem in wiring to motor -- if it doesn't problem in motor
I believe 1995 through 2005 fenders are all the same. Surely a 1996 and 1997 fender will fit a 1998 model.
R134a