It is in the side of the engine block behind the starter. You will have to remove the starter to see it and to get to it.
Do you have a picture of location of crankshaft position sensor for 1992 Chevy Cavalier 2.2L ohv engine?
The 2004 Chevy Malibu crankshaft position sensor location is dependent upon the type of engine. In most cases the crankshaft position sensor is on the back of the engine.
The location of the crankshaft position sensor depends on which engine the car has. If it is the 2.5L 4 cylinder engine the crankshaft position sensor is behind the ignition module. If it is the 2.8L V6 engine the crankshaft position sensor is on the side of the engine nearest the firewall and just above the pan rail in about the center of the block.
where is the cranksensor on 1994 chevy pickup with a 6.5 engine
It is located on the main bearings in the crankcase NEW ANSWER: The above answer is WRONG. The crank sensor is mounted in the side of the engine block BEHIND the STARTER. You MUST remove the starter to get to it.
It is behind the drivers side head and screwed into the rear of the engine block. It is hard to see and to get to.
Trouble code P1345 means: Camshaft To Crankshaft Position Correlation Fault
You will find the crankshaft position sensor on the passengers side of the engine block, close to the starter.
This sensor provides a signal to an engine management computer or an ignition control module or igniter indicating the position of the crankshaft.
The crank sensor target is on the crankshaft inside the engine on a 5.7L Hemi.
The crankshaft position sensor measures the rotational position of the crankshaft for the engine computer. That info is required for fuel and ignition timing.The crankshaft position sensor measures the rotational position of the crankshaft for the engine computer. That info is required for fuel and ignition timing.
The Crankshaft Sensor is located on the right rear of the engine block. It is about 6 or 7 inches from the flywheel.