0
Cub cadet 4125 strimmer starts after some work but onlys idles it stalls if you try and give it gas?
Zedshady
carb needs adjustment
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why you can't start your cub cadet?
Question is not specific enough. Could be battery, spark plug, solenoid, wiring, magneto, ignition switch, old gasoline left in tank & engine, etc.... Please re-ask your question and give more detail. ita 4125 strimmer it starts after some work then idles but cant give it any gas or it stalls
Whats the problem of my car starts and idles but stalls when you put it in drive or reverse yes its an automatic the car is a 87 Nissan sentra?
Probably an alternator.
Ford F-150 stalls after stop?
1987 ford f150 5.0 starts at 1500 rpms, then idles down to 700 rpms.truck idles low when put into gear and also stall when i stop from time to time.any help will be greatly appreciated.
What may be the problem 1991 Camaro 3.1 V6 fuel pump is good and has a new filter it starts up and idles great but when you give it gas it stalls?
Dirty injectors.
318 engine idles and stalls?
Need a little more info. What Model and year of the vehicle?
Your vauxhall vectra sometimes idles badly and stalls why is this?
idle control valve faulty or needs cleaning
1988 Mustang idles rough and stalls running rich?
Carb.? Float sticking? Rebuild or replace
Your battery light comes on and your car stalls out when it idles you drive a 2003 caviler why does this happen?
replace the alternator
1975 Vw transporter bus stalls when warm idles fine?
id change the coolant temp sensor
Pontiac sunbird stalls in gear but idles just fine?
Mine did this and I found out it was the timing belt that needed to be changed.
Car idles erratically and when put into gear it starts bogging out and eventually stalls also has a fuel smell coming out of the exhaust and some smoke after idling for 5 minutes?
I was told that this might be the EGR Valve either is clogged or going bad.
What will cause code to come back after replacing PS pressure switch it stalls and rough idles?
Did you manually clear the codes ?
