answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2009-09-11 19:42:08
2009-09-11 19:42:08

Was an intake manifold gasket for me.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Code P0304 on 2000 Ford Ranger is: Misfire at cylinder 4 detected. May be cause by a bad spark plug.


the slave cylander is located in the transmission on the 2002 Ford Ranger. Better see a mechanic to do the job.





The 2.3 liter DOHC 4 cylinder in a 2002 Ford Ranger has a ( timing CHAIN )


On a 1997 Ford Ranger , 4.0 liter V6 P0304 means that an engine cylinder misfire has been detected on the # 4 engine cylinder firewall 3 - 6 2 - 5 1 - 4 front of Ford Ranger ( V6 engine )


The firing order for a 2002 ford ranger is 1-3-4-2. The number one cylinder is at the front of the engine.


The 2.3 liter 4 cylinder in a 2002 Ford Ranger takes ( 5W-20 ) according to the Owner Guide


In a 2002 Ford Ranger : The 2.3 liter DOHC four cylinder engine has a timing CHAIN


The 2002 Ford Ranger owners manual shows : WITH FILTER CHANGE 2.3 L - 4 cylinder engine takes 3.8 liters ( 4.0 quarts ) of engine oil


where is the number 3 cylinder located on a 2.5 ford ranger engine


p0308 is a cylinder 8 misfire , can be several reasons why


The 2002 Ford Ranger in NORTH AMERICA has a 2.3 L DOHC four cylinder engine and the spark plugs are gapped at .044 inch


An engine cylinder misfire has been detected in the # 6 engine cylinder The engine cylinder locations are numbered : firewall 3 - 6 2 - 5 1 - 4 front


where is the valve located on the 2002 ranger 4.0 liter 6 cyl?


install ignition 2002 ford ranger directions


On a 2002 Ford Ranger , 4.0 liter V6 engine ( and the 3.0 ) firewall 3 - 6 2 - 5 1 - 4 front of vehicle


I am converting a ford ranger automatic (a4ld) transmission 4wd to a 5 speed manual from a 4 cylinder ford ranger. Will it work. What is needed?


There was a 2.9 L - V6 engine available in the Ford Ranger from 1986 to 1992


P0301 is cylinder number one misfire detected.P0301 is cylinder number one misfire detected.


I was looking at a picture on fordparts.com for the 2.3 liter DOHC engine in a 2002 Ford Ranger and the water pump is at the very front of the engine , towards the drivers side of the engine


how do you change motor mount on 2002 ford ranger


The slave cylinder for a hydraulic clutch on a Ford Ranger is inside the manual transmission bellhousing


firewall 3 - 6 2 - 5 1 - 4 front of Ford Ranger V6 ( 3.0 and 4.0 liter )



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.