Control memory is a random access memory (RAM) consisting of addressable storage registers. It is primarily used in mini and mainframe computers. It is used as a temporary storage for data. Access to control memory data requires less time than to main memory; this speeds up CPU operation by reducing the number of memory references for data storage and retrieval. Access is performed as part of a control section sequence while the master clock oscillator is running.
The computer architecture is concerned with how the CPU acts and uses the computer memory.
The computer architecture is concerned with how the CPU acts and uses the computer memory.
Segmentation is part of physical memory ares.
That depends on the operating system and computer architecture.
commonly refers to the slot computer memory is placed it on the computer motherboard or i/o board
Direct Addressing in computer systems architecture is when the number in the address field of the instruction is the actual memory address to be accessed.
It depends on the computer, every computer is different. If you want to check your memory go to Start > Control Panel > System. There you can find information about the computer, and also the memory.
Depending on the architecture of the computer one addressable memory location might be called a word, a character, a parcel, a decimal digit, a byte, etc.
It all depends on the architecture that the processor is built on. If it is 32 bit architecture, 2^32 it will be 4gb. If it is a 64bit processor it can access 2^64 memory locations, or 16gb.
Swapping means to swap the values of two addresses in main memory.
The definition of PC2700 is a type of RAM memory chip that has been used in computers for a while. 512MB is the amount of memory that can be found in the computer.
DSM stands for "distributed shared memory". Distributed shared memory is a computer architecture where the memories can be addressed as one address.